Sunfire IV manual Front Panel Features

Page 10

CHAPTER 1

Front Panel Features

1

2

3

4

5

6

SIGNAL PROCESSING

DOLBY

ZONE TWO

DIGITAL

POWER

Theater Grand

ROTATION

LEVEL

DTS

ZONE TWO ADJUST

 

MODE

DOWN

UP

PRO LOGIC IIx

HOLOGRAPHIC IMAGE

DIGITAL SOURCE

SIDE-AXIS

ZONE

HOLOGRAPHIC

TWO

IMAGE

TREBLE

PANEL

DIM

POWER

Theater Grand IV

1

2

3

4

5

6

7

8

9

0

+10

SELECT

 

 

 

 

 

 

 

 

 

 

 

 

BASS

MUTE

Sonic Holography Nine point One Channels Surround Sound Processor

 

 

 

 

MANUAL

 

 

 

 

 

 

 

 

 

 

 

 

TUNING

 

 

 

 

 

 

 

 

 

AM/FM

DIRECT

DOWN

 

 

UP

 

 

DOWN

 

 

UP

FULL AUTOMATIC

 

TUNER CONTROLS

 

Sunfire

 

TONE CONTROLS

 

OPERATION

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

MANUAL INPUT SELECTOR

7

8

9

1. Signal Processing

DOLBY DIGITAL

This light is on when a Dolby Digital signal is being decoded.

DTS

This light is on when a DTS signal is being decoded.

DOLBY PRO LOGIC IIx

This light is on when the Dolby Pro Logic IIx mode, or Dolby Pro Logic II mode is engaged.

DIGITAL SOURCE

This light is on when a Digital signal is being decoded.

ZONE TWO POWER

This light is on when Zone 2 is turned on.

ZONE TWO ADJUST

This light is on when Zone 2 is being adjusted.

HOLOGRAPHIC IMAGE

This light is on when the HOLO- GRAPHIC IMAGE "circuit" is engaged. (This is actually modeled in DSP).

SIDE AXIS

This light is on when the side- axis outputs are enabled.

1011

2. IR Receiver Window

This window should be clean and free from obstruction for the remote control to work correctly.

3. Display

This soothing blue display shows which input is selected, the tuner frequency, volume level, and other useful features.

4. Mode Buttons

MODE UP/DOWN

These buttons allow you to step up or down through the various sound playback modes.

ZONE TWO

Note: If Zone 2 has not been enabled (see page 36) this but- ton has no effect.

Any changes you make after pressing this, will affect Zone 2 and not the Main Zone. For ex- ample, press this and POWER to turn on Zone 2, then adjust the Volume and select an input. Press ZONE 2 again to revert back to Main Zone operation. It will also revert back after a short period of no activity.

12 13

TREBLE/BASS SELECT Use these buttons to select either the Treble or Bass for ad- justment using the UP/DOWN TONE controls (11).

HOLOGRAPHIC IMAGE Engage this "circuit" to add a three dimensional effect, espe- cially to stereo listening.

PANEL DIM

The front panel lights have four levels: bright, medium, low and off (low intensity display with amber LEDs off).

MUTE

This turns off the sound. Press it again, or adjust the volume control to return to the previous volume level.

5. Rotation

This light pulses when the front panel volume LEVEL or INPUT SELECTOR are being rotated, or when you are using the remote control.

10

User's Manual

Image 10
Contents Theater Grand Safety Instructions NEC National Electrical Code Contents Introduction Remote Features FeaturesUnpacking Overview MainTgiv Quick Start GuideExit Further Information Front Panel Features Level PowerTuner Presets Illuminated Logo PanelRear Panel Features FM Antenna RS-232 PortXLR Audio Outputs AM AntennaInstallation System Confi gurations Analog audio and composite videoDigital audio and component video connections RandLD connections external RF Demodulator and S-Video DigitalVCR connections analog audio and composite video GrandCD and Antenna connections AM Loop AntennaTurntable connections Tape Player connections Channel Input connections analog audio GrandAmplifi er connections Zone 2 connections Remote Control Main Audio Operating the Tgiv with the RemoteZone ENTRemote Setup PRORemote Setup LearnRecal Recall MacroOSD Activation On Screen Display OSDQuick Information OSD Menus Trims Menu Trim and Tone MenusTone Menu Modes Menu Modemusic Center Width Panorama on DimensionModes Menu Pro Logic IIx MenuInput Confi guration Menus Input MenusInput Menus Tuner Preset Menu Tuner Preset MenusPreset procedure Zone 2 Menu Main Zone and Zone 2 MenuMain Zone Menu Control Menu Video, Software and Control MenusSoftware Menu Video MenuSpeaker Size Menu Speaker Size MenuSpeaker Position Menu Speaker PositionSpeaker Calibration Menu Speaker CalibrationSpeakers Crossover adjustment Subwoofer ModeSpeaker Crossover Menu CrossoverBass Management Using the TgivVideo Conversion Dolby PRO Logic II Surround Modes for 2-Channel SourcesDTS Neo6 DTS Surround Modes for Multi-Channel SourcesDTS ES Tuner Operation Recording to a Tape Player RecordingRecording to a VCR Connections IndicatorsZone 2 Operation Turning on ZoneHolographic Image Software Upgrade Software Revision ListSoftware CD Front Speakers Speaker PlacementAppendix Center speakerSurround Back Speakers Side-Axis SpeakersSurround speakers Subwoofer LocationRS-232 Port Troubleshooting Guide Same AM station can be heard at different frequenciesNo Dolby Digital, DTS playback Your amplifiers shut down often Remote Control Codes Televisions Tape DecksVCRs Mode Settings Tone SettingsZone Settings Video SettingsSpecifi cations Limited Warranty Service AssistanceManual part number 913-107-00 Rev B