Electric Pressure Fryer | Operation | |
|
|
|
|
|
|
Item # | Description | Function |
1 | Spin Handle | Used to tighten the lid to the pot once it is latched. |
2 | Pop Safety Valve lever | Used to release pressure periodically to prevent the seat from |
|
| sticking. |
3 | Pressure Gauge | Indicates the pressure inside the pot. |
4 | Computer | Used to set and activate product programs. |
5 | Rocker Switch | FILTER – When placed in this position, power is applied to the |
|
| motor and shorting is pumped into the pot directly or thru the fill |
|
| hose. |
|
| OFF – When placed in this position, power is removed from both |
|
| the pump motor and heating elements. |
|
| FRY – When placed in this position, power is supplied to the |
|
| thermostat and heating elements. |
6 | Thermostat Knob | Used to set the temperature of the shortening. |
7 | Thermostat Light | Illuminates until the set temperature of the shortening has been |
|
| reached. |
8 | Digital Timer | The digital timer consists of an LED, display, beeper and 8 |
|
| buttons described below: |
| LED indicator | Prior to the start of a timing cycle the LED will be OFF. When |
|
| running a timing cycle the LED will flash. At the end of a timing |
|
| cycle the LED will turn ON steady. When idle the LED is off. |
| TIME SELECT (2 | Two arrow buttons on the front panel are used to set the time. |
| arrow buttons) | Hold the UP ARROW button down to increase the time. The |
|
| longer the button is held down, the faster the rate at which the |
|
| time will increase. The DOWN ARROW button is used in the |
|
| same manner as the UP ARROW button except it will cause the |
|
| time to decrease. The time is increased or decreased in 30- |
|
| second increments. |
| START/STOP | Starting the Timer - Pressing this button while the timer is not |
| button | active will cause the timer to begin counting down the time on the |
|
| display. |
|
| Stopping the Timer - Pressing this button while the timer is |
|
| active will stop the timer from counting down and display the |
|
| remaining time. Time cannot be changed with the TIME SELECT |
|
| buttons at this point. If this button is pressed again the timer will |
|
| continue counting down from the point it was stopped. |
|
| Resetting the Timer - Pressing and holding this button for longer |
|
| than two (2) seconds will reset the timer and the display will return |
|
| to the original starting time. At this point, time can be changed |
|
| using the TIME SELECT buttons or the preset buttons. |
|
| Canceling The STIR OIL Function - Pressing this button cancels |
|
| the STIR OIL function while it is active. |
11