Bakers Pride Oven LPF-FC service manual Electric Pressure Fryer Operation

Page 24

Electric Pressure Fryer

Operation

 

 

4.Carefully drop the chicken in the shortening one piece at a time starting with thighs and drumsticks. The fryer is designed to accommodate 32 pieces of chicken.

Failure to use the insulated mitts will result in severe injury. Always use the insulated mitts when handling the hot fry basket.

5.Lift the basket and shake it. This keeps the food from sticking together and causing white spots on the cooked food.

Hot shortening may splash out of the pot causing severe injury when lowering basket into pot. Carefully lower basket into pot to prevent shortening splashes.

6.Slowly lower the fryer basket into fryer pot.

7.Close the lid. Make sure the lid snaps shut. Make sure the lid hook latches securely under the catch.

8.Tighten the spin handle until the lid is firmly sealed. Then line up the orange knob on the spin handle with the orange knob at the front of the fryer.

9.Press the desired program number a second time. The red light above the program number will flash and the computer will display “COOK”. This will start a countdown in minutes and seconds until the end of the cycle.

10.At the end of the cooking cycle, the computer will display "DONE" and signal with a series of audible "beeps". Press the selected number once again to stop the cook cycle. Fifteen seconds before the end of the cook cycle, the program will automatically release the pressure from the fryer. For your safety, the lid will not unlock, even at the end of the cook cycle, until the pressure has been fully released.

Hot steam will escape when you open the lid possibly causing severe injury.

Keep your face and arms away from the fry pot.

11.Slowly turn the spin handle counterclockwise to break the seal around the lid. Your fryer has a locking pin that prevents turning the spin handle until the pressure drops to "0".

12.Slowly open the lid.

Failure to use the insulated mitts will result in injury. Always use the insulated mitts when handling the hot fry basket.

13.Lift the basket and hang it on the front of the fryer pot to drain.

14.Empty the basket.

15.Remember to filter the shortening at least every third frying cycle load. Refer to the procedure in this manual. Also filter the shortening and clean the fryer at the end of each day.

16.Close the lid and press the 0 button. Idle 255F will display. This will automatically hold the shortening at a cooler temperature.

17.To escape the idle mode, press the 0 button again and the fryer will heat to its original temperature.

18.When you have finished frying for the day, turn the FILTER/OFF/FRY switch to the OFF position.

22

Image 24
Contents Electric Pressure Fryer Warranty Information Table of Contents Safety Precautions Safety Signs and MessagesSpecific Precautions Equipotential ground planeFull Disconnection Noncombustible Floors Only Safe Work PracticesDo Not Overload The Basket With Food Never Loosen The Spin Handle Until Pressure Gauge Is At Zero Keep Safety Labels Clean and in Good Condition Safety Labels Installation Controls and Indicators OperationCanceling The Stir OIL Function Pressing this button cancels Item # Description FunctionElectric Pressure Fryer Operation Care of the Shortening LPF and LPF-F OperationStart-Up LPF and LPF-F KEY Display Mode Description Cooking LPF and LPF-FElectric Pressure Fryer Operation LPF-FC Operation System ProgrammingStep Action Display Comments Product Programming Product Programming SequenceProgram Product # Step Action Display Comments ALF and BLF AutomaticStart-Up LPF-FC Cooking LPF-FCElectric Pressure Fryer Operation Recipes Whole Turkey 12 to 14 pounds Whole DucklingPork Chops Cube Or Minute SteaksMaintenance Description Assembly # AssembliesItem # QTY Description Drain Valve Replacement Thread Insert 10-24 Steel Drain/Motor/Piping Assembly VALVE,DRAIN SS BALL&PLT.CAR.STEM Control Panel LPF/LPF-F FUSE, 15A 300V SC15 Time Delay Control Panel LPF-FC Control Panel LPF-FC Parts Lid/Top AN8620560S, Sheet 1 Lid/Top AN8620560S, Sheet 2 Lid/Top AN8620560S, Sheet 3 Lid/Top AN8620560S, Sheet 4 LID/TOP AB86200700 Oil Vat Assembly AN86202800 Quik Disconnect Bracket Weldment Accessories Description Accessory #Components Description Component #Components Electric Pressure Fryer Replacement Parts Wiring Diagram Diagram # Figure #LPF-F 208V/60HZ/1 or 3 Phase 240V/60HZ/1 or 3 Phase LPF 208V/240V, 3 Phase LPF 220V/380V1 or 3 Phase or 240V/415V 1 or 3 Phase LPF-FC 208V/3 Phase or 240V/3 Phase LPF-FC 208V/60HZ/1 Phase LPF-FC 240V/415V/3 Phase or 220V/380V/3 Phase LPF-F 220V/380V/3 Phase or 240V/415V/3 Phase Electric Pressure Fryer Electric Pressure Fryer Electric Pressure Fryer LI0804/1008