Electric Pressure Fryer | Introduction |
Do Not Overfill The Fryer With Shortening
Hot shortening and steam may escape and burn you if you put too much shortening in the fryer. Fill the fryer to approximately one inch below the fill marks that are inside the fryer pot. Heat the shortening. If needed, carefully add more shortening to bring the level to the fill marks.
Do Not Let Any Water Get Into The Fryer
Always remove excess moisture from food before placing it into the fryer basket. Water will cause the hot shortening to spatter. You could be burned.
Do Not Overload The Basket With Food
Hot shortening and steam may escape and burn you if you place too much food in the basket.
Always Make Sure The Lid Hook Is Latched
When Closing The Fryer
To make sure the lid hook is latched properly, press down the lid until the hook snaps shut. Hot shortening and steam can escape if the lid hook is not latched properly. You could be burned.
Keep Away From The Vent
Hot steam escapes from the vent continuously when you are using your fryer. You could be burned if you get too close to the vent.
Seal The Safety Valve Properly
To seal the safety valve, lift the arm on the side of the valve. Then release it. The valve should snap closed. Hot steam can escape from the valve and you could be burned if you do not seal the valve properly.
Always Tighten The Spin Handle When
Closing The Fryer
Hot shortening and steam can escape if you do not tighten the spin handle properly. You could be burned. Line up the orange knobs on the fryer lid handle and the front hook when tightening.
Do Not
You could damage the fryer.
5