Vermont Casting VC100 user manual Lighting the Rotisserie Burner Models VC200 & VC400

Operation

Lighting the Rotisserie Burner (Models VC200 & VC400)

The Rotisserie burner provides the steady, even heat required to cook poultry and roasts to self-basted perfection.

To start the Rotisserie burner :

1. Always open the Hood completely before attempting to light the Grill.

WARNING : Never stand with your head directly over the Grill when preparing to light the Rotisserie burner, to prevent possible bodily injury.

2.Always confirm that all of the burner control knobs are in the OFF position before opening the gas supply.

3.Turn on the propane gas supply valve at the tank (1 to 2 turns) or turn on the main natural gas supply valve.

4.Turn the Rotisserie Burner Control Knob to the HI position, by pushing down on the knob and turning it counterclockwise.

5.Immediately push the Igniter Button. The Rotisserie burner should light within four seconds.

•WARNING : IF THE ROTISSERIE BURNER DOES NOT LIGHT, immediately turn the burner control knob to the OFF position, to prevent gas buildup. Wait five (5) minutes for the gas to clear and then repeat the preceding starting procedure. If the burner will not light when using the Piezo Igniter, follow the match lighting instructions below.

6.Confirm that the burner is properly lit and that the flame pattern is as desired, (see Figs. 9a, 9b & 9c, for the proper flame patterns). If the flame pattern is other than normal, consult the Troubleshooting Guide on Page 26 for corrective action.

7.Always preheat the Grill before starting to cook on the rotisserie.

VERMONT

VERMONT

Castings

Match Lighting the Rotisserie Burner

1. Always open the Hood completely, before attempting to light the Grill.

WARNING : Never stand with your head directly over the Grill when preparing to light the Rotisserie Burner, to prevent possible bodily injury.

2. Always confirm that all of the burner control knobs are in the OFF position before opening the gas supply.

3. Turn on the propane gas supply valve at the tank (1 to 2 turns) or

turn on the main natural gas supply valve. 4. Insert a lit match or a butane lighter into the match lighting hole located

below the rotisserie screen (see Fig. 11).

5.Turn the Rotisserie Control Knob to the HI position by pushing down on the knob and turning it counterclockwise.

Rotisserie Lighting Hole

Fig. 11

Page 10