Wall Hood Installation

USER manual 9

Plan where the ductwork will be located. Install proper-sized duct work, and roof or wall cap, depending on where you will be venting your hood. Recommended and most com- mon installations are shown in the venting diagrams above. Adjust your measurements to accomodate heights of ceilings, cabinets, or rangetops.

STEP 1 Install anchors and screws

Markings you’ll need:

♦♦ center line of installation area ♦♦ location of studs

♦♦ horizontal line 28” - 36” above the cook top (this is where the bottom of the range hood will be)

Use one panel of the cardboard ship- ping box to trace an outline of the hood.

♦♦ Place the cardboard panel against the range hood and trace an outline

♦♦ Find the center point of range hood (directly between mounting holes) and mark it on the cardboard panel

♦♦ Find the mounting points on the hood and mark them on the panel

♦♦ Transfer the panel to the wall, lining the bottom of panel to the horizontal line

♦♦ Line up the center point of the panel with center point on the wall

♦♦ Find mounting points on the card- board and poke holes through it, marking where you will mount the hood to the wall.

♦♦ Predrill holes where your mounting marks are, then insert wall anchors and mounting screws