Kobe Range Hoods CH7948SQ, CH7930SQ, CH7942SQ, CH7936SQ manual

-If necessary, attach two rubber stands (provided) withscrewst o (provided)4x8 mm) to the back of the hood.

-Attach the hood-mounting bracket to the back of the hood with nine (3/16￿ x screws (provided) as shown in Figure 25.

Hood Installation

CAUTION: If required to move the cooking range to install the hood, turn OFF the p electric range at the main electrical box. SHUT OFF THE GAS BEFORE MOVING A GAS RANGE.

1.Using references on Table 2 and measurements on page 21-22, mark the leveling of the hood. Position two mounting screws (not provided) on the wall, leaving from the wall as shown in Figure 26.

Mounting

Screws

Figure 25

2.Use aluminum or steel pipe to connect the exhaust opening at the rear of the h ductwork. Use duct tape to make all joints secure and air tight.

3.Align hood-mounting bracket to the two screws on the wall and hook hood into p Tighten screws to secure hood to the wall. CAUTION: MAKE SURE THE HOOD IS SECURE BEFORE RELEASING.

Duct Cover Installation

4.Mark the position of the duct cover-mounting bracket. EUsefromreferenceTable 2 and measurements on page 21-22. Attach and secure duct cover-mounting bracket wit screws (not provided). Refer to Figure 27. NOTE: Inner duct cover will cover mounting bracket.

5.Connect electrical wires. Refer to ￿Wiring to Power Supply￿ on page 16

6.Slide the inner duct cover up 2 inches before sliding the entire duct cover on Refer to Figure 28.

14