Enviro installation instructions Horizontal Vent Kit 50-1235, KIT Components

Horizontal Vent Kit

50-1235

Please read and understand these instructions before installing. Failure to follow these

instructions carefully could cause property damage or personal injury.

For use with Haven & Retreat Direct Vent fireplaces.

KIT COMPONENTS:

Quantity	Description		Quantity	Description
1	Horizontal direct vent termination cap		4	Wire spacers
1	Flue collar adapter		1	4 oz tube Mill-Pac Sealant
1	Wall thimble		1	4 oz tube RTV silicone
1	5’	(190 cm) length of Ø4” (10 cm) double walled flex pipe	12	9/16” tech screws
1	5’	(190 cm) length of Ø6⅝” (10 cm) double walled flex pipe	8	1½” wood screws

Please ensure that all components are supplied with this kit. If components are missing or have been damaged, contact your dealer, distributor, or courier company. Do not attempt the installation if components are missing or damaged.

INSTALLATION INSTRUCTIONS:		10"
		(254mm)
1. Plan your installation and clearances to combustibles. Decide on a location
for the unit that will meet any or all local code requirements. Refer to the		10"
sections in your owner’s manual on where to locate your stove.
		(254mm)
2. Set the appliance in the desired location. Determine if any wall studs,
electrical wiring, or plumbing pipes are in the way of the venting system
as it passes through the exterior wall. The fireplace location should be
adjusted if obstructions are found in the wall.
	3. Project a line from the center point of the flue
	outlet upward and outward to the desired flue
	outlet location on the exterior wall. Using this
	center point, scribe a 10” (25.4 cm) hole or
	square on the wall. Cut the hole out on both
		Figure 1
	the interior and exterior wall surfaces.
	4. Frame the hole as shown in Figure 1.
	5. Trim the Wall Thimble to match the wall thickness as necessary. Install the wall
	thimble and secure it to the inner wall frame using four (4) 1½” wood screws.
Wire	6. Apply a bead of Mill-Pac Black sealant to the new Ø4” (10 cm) by 5” (12.5 cm)
spacers	provided flue collar adaptor. Press the flue collar into the flue outlet of the
	fireplace so that the Mill-Pac seals the flue collar to the flue outlet.
	7. Stretch both the Ø4” (10 cm) flex vent and the Ø6⅝” (16.25 cm) flex intake
	liner to the length needed to ensure the flex can be easily connected to the vent
	terminal.
	8. Slide the Ø6⅝” (16.25 cm) flex intake liner over the flex vent. Install four (4)
	wire spacers around the flex pipe. Ensure the wire spacers are positioned at
	either end of the pipes, and at each end of any elbows in the liners (refer to
	Figure 2 and 3).

Figure 2