Hunter,R.F 83005 manual D11, D12, D13, D15, Existing Construction accessible only from below

Existing Construction – accessible only from below

D11 EXISTING FAN

D12

F

Remove an existing fan and check to make sure the open-	Move the housing into position above the ceiling
ing is large enough to accommodate the new motor hous-
ing (9”x 9.75”).

D13

Route wires through the strain relief. For supply connection,

use wires suitable for at least 90º C (194º F).

D14

2

1

Attach existing ducting to duct connector. Tape joints.

If ducting does not fit securely,

an adapter may need to be purchased.

D15

F

Screw pre-loaded screws into joist or framing.

41952-01 3/13/2006

05-HF-008-Eng_3.13.06.indd 15

15

3/13/06 12:09:04 PM