Zanussi ZHC705, ZHC905, ZHC605 To Remove/Replace Charcoal Filters, Changing the Light Bulb

Page 7

MAINTENANCE AND CLEANING

Charcoal Filters

In the recirculation mode the charcoal fi lters absorb smells and unwanted odours.

The charcoal fi lters cannot be cleaned, we recommend they should be replaced approximately every three months or more often if the hood is used for more than three hours per day.

To Remove/Replace the

Charcoal Filters

1.First remove the metal grease fi lters.

2.Rotate the charcoal fi lter anti-clockwise

(A) and remove.

3.To replace the charcoal fi lters, remove the metal grease fi lters.

4.Place the fi lter over the inlet grille at either end of the fan housing and rotate clockwise (B) into position.

This appliance can be a possible fi re hazard if the grease and charcoal fi lters

are not cleaned and replaced as recommended.

Changing the Light Bulb

1.Remove the screw fastening the lamp cover.

2.Rotate the light bulb anti-clockwise to unscrew.

3.To replace the light bulb insert a replacement into the holder then rotate the bulb clockwise into position. Ensure you take care not to overtighten the bulb.

4.Replace the lamp cover.

If the light bulb fails to function check that the bulb is fully screwed into the holder. If bulb failure has occurred then it should be replaced with a 220-240 Volt 40W clear globe shaped bulb with a small E14 screw thread.

Replacement filters and light bulbs can be obtained from your local Service Force Centre.

B A

7

Image 7
Contents Cooker Hood Operating Instructions For the User For the InstallerMaintenance and Cleaning Service Force CentresMaintenance and Service Important Safety InformationInstallation Child SafetyFan Control Your Appliance Operating InstructionsCooker Hood Controls Worktop LightingSelect the required fan speed and light if required To OperateRecirculation ExtractionRemove the metal grease filters one at a time by Maintenance and CleaningExternal Cleaning Metal Grease FiltersTo Remove/Replace Charcoal Filters Charcoal FiltersChanging the Light Bulb Symptom Solution Service and Spare PartsSomething not Working Guarantee Conditions Electrical Connection Installation InstructionsElectrical Connections Electrical RequirementsScrews M4x25 Installing the Cooker HoodInstallation Requirements UnpackingBuilt-in Gas hob 30 1/2 when installed above a slot-in gas cookerClearance Height Built-in Electric HobFitting the Canopy Hood Fitting the Wall Brackets150 Recirculation ModeExtraction Ducted Fitting the DuctingFitting the Lower Chimney Fitting the Upper Chimney43600252901