Garland MCO-GD-10E, MCO-GD-10M, MCO-GS-10M, MCO-GS-10E To Remove Doors from the Oven, File Name

Page 18

2.Locate stainless steel door gasket, mounted to oven front frame.

3.Remove the #10 Phillips sheet metal screw that attach the retainer to the oven's front frame.

4.Remove stainless steel door gasket.

5.Replace stainless steel door gasket and to reverse above procedure to re-install.

FILE NAME

JIT03418

To Remove Doors from the Oven

1.Remove top front cap veneer.

Image 18

Contents Direct ON-SITE Service 1-800-451-1165 General Information GarlandTable of Contents Specification & DimensionsOverview of Operational Sequences Component Access of Functional Components Common Wire DiagramsPilot Orifice PRES. W/C GAS Convection Oven GAS Specifications Main Pilot TotalDimensions & Specifications AMT Orifice NAT PROManual Controls M Calibration of ThermostatInstrumentation Weighting Thermostat Operation Calibration NotesElectronic Controls E Electronic Control Failure Codes TempRobertshaw COM6000 Controller Operation of the Pulse Function Operation of the Temperature FunctionOperation of the Timer Function User Preference Offset for the Electronic ControllersTo SET Oven Into Pulse Mode Timer Resolution ChangingTo SET Hold Temperature Change the HertzSafety Lockout Time Chain ProgrammingSecond Stage Main Burner Operation Start Stage ENDStart YES Spark Stops When Pilot is LIT?Troubleshooting Ends S86 Checkout YES Spark Across IGNITOR/SENSOR GAP Control Module Flame Sensor Circuit Check Grounding Check Spark Ignition Circuit Examples of Unsatisfactory Pilot FlamesAppearance Cause Right Front Component LocationsTop Front Center Lower FrontTo Remove Doors from the Oven File NameTo Reinstall Doors onto Convection Oven Installing and Adjusting Door ChainDisassembly of the Left Door Disassembly of the Right Door w/o window Page To Replace or Adjust Door Latch Mechanism To Replace Convection Oven Motor Assembly Drawing BelowConvection Oven Motor Assembly Page Common Wire Diagrams Page