To Replace or Adjust Door Latch Mechanism
1.Open oven doors.
2.Remove 2 pan head Phillips screws.
3.Lift door latch mechanism up and out of door assembly.
4.To adjust latch mechanism , loosen lock nut & and adjust by tightening or loosening adjustment nut.
To Replace Convection Oven Motor Assembly
(Drawing Below)
1.Open doors and remove all oven racks.
2.Remove 4 #10 sheet metal screws (that secure air baffle) and remove air baffle.
3.Remove six hex nut
4.Place a piece of cardboard on oven floor to protect from
scratching or chipping.
5.Pull entire motor assembly (1A) away from rear oven wall into oven cavity and place on cardboard.
6.Disconnect wiring, be sure to note wire locations.
7.To reinstall reverse above procedure.
1A
4A
FILE NAME
JIT00024
2A
1
3
6
2
4
5
Convection Oven Motor
22