Garland MCO-GS-10M, MCO-GD-10M, MCO-GD-10E, MCO-GS-10E service manual

Page 21

NOTICE: DEPENDENT RIGHT HAND DOOR SHOWN.

1.Once the door has been removed from the oven (refer to instructions on page 19), remove 9 truss head s.m.s. 10 x ½ from the top, bottom and left side (as shown) from the door panel

2.Pry the door liner apart from the door panel . This will expose the door frame .

3.To reassemble, reverse above procedure.

Image 21

Contents Garland Direct ON-SITE Service 1-800-451-1165 General InformationTable of Contents Specification & DimensionsOverview of Operational Sequences Common Wire Diagrams Component Access of Functional ComponentsDimensions & Specifications GAS Convection Oven GAS Specifications Main Pilot TotalPilot Orifice PRES. W/C AMT Orifice NAT PROManual Controls M Calibration of ThermostatInstrumentation Weighting Calibration Notes Thermostat OperationElectronic Controls E Electronic Control Failure Codes TempRobertshaw COM6000 Controller Operation of the Timer Function Operation of the Temperature FunctionOperation of the Pulse Function User Preference Offset for the Electronic ControllersTo SET Hold Temperature Timer Resolution ChangingTo SET Oven Into Pulse Mode Change the HertzSafety Lockout Time Chain ProgrammingSecond Stage Main Burner Operation END Start StageTroubleshooting Ends S86 Checkout YES Spark Stops When Pilot is LIT?Start YES Spark Across IGNITOR/SENSOR GAPCheck Spark Ignition Circuit Check GroundingControl Module Flame Sensor Circuit Examples of Unsatisfactory Pilot FlamesAppearance Cause Top Front Center Component LocationsRight Front Lower Front File Name To Remove Doors from the OvenTo Reinstall Doors onto Convection Oven Installing and Adjusting Door ChainDisassembly of the Left Door Disassembly of the Right Door w/o window Page To Replace or Adjust Door Latch Mechanism To Replace Convection Oven Motor Assembly Drawing BelowConvection Oven Motor Assembly Page Common Wire Diagrams Page