Hunter Fan 41787-01 manual B10 B11, B14, B13

Page 10

B10

D

B11

Move the housing into position above the ceiling.

Pull the wires through the strain relief and tighten the

 

strain relief screws.

B12

2

1

Attach existing ducting to duct connector. Tape joints.

If ducting does not fit securely,

an adapter may need to be purchased.

B14

D

Connect the wiring.

B13

D

Fit housing into the opening and secure by tightening the

pre-loaded screws into the joist.

Note: Install the box flush with the sheetrock (ceiling).

10

41787-01 1/11/2006

Image 10
Contents Installation I d e Preventative Maintenance Before Installation X2 HNew Construction Installation Loosen screw securing motorA10 A11A15 A14A160 A19 A17A18 A21 A22Existing Construction Installation Existing FanInsert the strain relief into the housing and secure B14 B10 B11B13 B16 B17 B15B18 B19 B21 B22Attaching the Grille Screw glass dome into position Trouble Shooting SolutionWarranty Limited WarrantyFrisco Avenue, Memphis, Tennessee Desde Í a S t a l a c i ó nPrecaución Antes de la instalación Instalación para construcción nueva A10 Tire de los alambres por el aliviador de tensiones A21 Encendido ApagadoInstalación para construcción existente Retire las cubiertas de las puntas de tornillo precargadas Conecte el cableado B15 Fijación de la rejilla Retire los tornillos de manoEnrosque el domo de vidrio en su posición Solución de problemas SoluciónGarantía Garantía LimitadaFrisco Avenue, Memphis, Tennessee Impreso en China