Connect the electrical wires as follows:
3 Connect wires tightly and securely using wire connectors (not supplied).
• Black to Black
• White to White
• Green to Green
Range Hood
Conduit
Wire Connector (not supplied)
Wire (unit side)
Make sure that all wires are connected
4 properly and enclosed inside of the wiring compartment.
Wire (conduit side)
4. FINAL ASSEMBLY AND CHECK
Two 60 W light bulbs (not supplied) can be mounted to this range hood. Prior to final assembly, install light bulbs (halogen or ordinary type, in the base diameter 26 mm), rated 120 V - 60 W or below.
Assembly (refer to “PREPARATION”)
1 (1) Replace the fan case cover with 4 screws.
(2) Replace the Rectifier Baffle Panel with 2 screws.
(3) Install the oil catch tray.
2 | Check |
(1) Turn on the electrical circuit to the range hood. |
(2)Make sure that the switch and light operate correctly. Refer to page 5 of the Operation Manual.
(3)Check the ventilating functions at High ( 
), Medium ( 
) and Low ( 
) positions.
(4)Make sure that the range hood has no abnormal noises and/or vibration.
CAUTION: • To reduce the risk of injury, keep your hands and other objects away from the fan while it is in motion.
• Wear working gloves to avoid injury.
13