Always light the burner before you put cookware. To light the burner:
1.Turn the control knob counterclockwise to the maxi-
mum position ( 
) and push it down.
2.Keep the control knob pushed for approximately 5 seconds; this will let thermocouple to warm up. If not, the gas supply will be interrupted.
3.Adjust the flame after it is regular.
If after some tries the burner does not light, check if the crown and its cap are in correct positions.
1
2
3
4
1Burner cap
2Burner crown
3Ignition candle
4Thermocouple
Warning! If the burner does not light after 15 seconds, release the control knob, turn it into off
position and try to light the burner again after minimum 1 minute.
Turning the burner off
To put the flame out, turn the knob to the symbol 
.
Warning! Always turn the flame down or switch it off before you remove the pans of the burner.
Lid Safety Device
Lid has safety device, which cut off gas supply for hob. It works only when lid is closed.
Warning! Always use the control knob to switch off a burner. Do not use the lid as a
Hob - Helpful hints and tips
Energy savings
•If possible, always put the lids on the pans.
•When the liquid starts to boil, turn down the flame to barely simmer the liquid.
Use pots and pans with bottom applicable to the di- mension of burner.
Burner | Diameters of cookware |
Rapid | 180 mm - 260 mm |
Burner | Diameters of cookware |
120 mm - 220 mm | |
Auxiliary | 80 mm - 160 mm |
Use cookware with the bottom as thick and flat as possi- ble.
Hob - Care and Cleaning
Warning! Refer to "Safety information" chapter.
Warning! Switch the appliance off and let it cool down before you clean it.
Warning! For safety reasons, do not clean the appliance with steam cleaners or
cleaners.
Warning! Do not use abrasive cleaners, steel wool pads or acids, they can cause damage to the
appliance.
•To clean the enamelled parts, cap and crown, wash it with warm soapy water.
•Stainless steel parts wash with water, and then dry with a soft cloth.
7