Dimension | mm |
F | less then 400 |
Levelling
Use small feet on the bottom of appliance to set same lev- el of cooker top surface with other surfaces
The stability chain
Caution! You must install the stability chain. If you do not install it the appliance can tilt.
Before you install stability chain, adjust the appliance to the correct height.
Measure down 180 mm from the appliance top surface, then measure right 30 mm (See picture). Mark the posi- tion of the wall and this gives anchor point for the stability chain.
180 mm
30
mm
Warning! These instructions are only valid in the countries whose symbols appear on this booklet's
cover. |
|
|
|
|
|
Gas Category |
| I2H |
Gas Supply |
| G20 - 20 mbar |
|
|
|
Gas burners
BURNER
Auxiliary burner
Rapid burner
Grill
Top Oven
Main Oven
NORMAL POWER
kW
1,0
1,9
3,0
2,7
1,9
1,9
NATURAL GAS
inj. 100/mm | Btu/h |
70 | 3412 |
96 | 6483 |
119 | 10236 |
120 | 9212 |
99 | 6483 |
99 | 6483 |
Gas Connection
Use a flexible pipe in compliance with the regulation in force. Be careful they do not come in touch with mobile parts or they are not squeezed.
Warning! Only a qualified and competent person must do the gas installation.
Warning! Before gas connection disconnect the mains plug from the mains socket or switch off the
fuse in the fuse box. Close the primary valve of the gas supply.
Supply piping should not be less than R3/8. Con- nection is made to the Rc ½ (1/2 “ B.S.P.) female threaded. Entry pipe located just below the hob level on
the rear left hand side of the appliance.
The gas supply ramp is on the rear side of the appliance.
Warning! Only liquid sealants to be used when inlet gas pipe is fitted i.e.: do not use P.T.F.E. sealant
tape.
When installation is complete. Carry out a gas tightness test and make sure that the seal of each pipe fitting is correct.
20