Zanussi ZDF 501 Something not working, Dishwasher will not start or stops during operation

Something not working

IMPORTANT!

The dishwasher will not start or stops during operation.

Certain problems are due to the lack of simple maintenance or oversights, which can be solved with the help of the indications described in the chart, without calling out an engineer.

Open the door and carry out the following suggested corrective actions.

IMPORTANT!

When carrying out the suggested corrective actions the appliance must be switched off.

	Fault code / malfunction	Possible cause	Solution
The dishwasher does not fill with		The water tap is blocked or furred	Clean the water tap.
		with limescale.
water.
		The water tap is turned off.	Turn the water tap on.
- continuous flashing of the
	light of the running programme	The filter (where present) in the .	Clean the filter in the.
-	appears in the digital	threaded hose fitting at the water	threaded hose fitting.
		inlet valve is blocked.
	display	The water inlet hose has not been	Check the water inlet hose
		correctly laid or it is bent or	connection.
		squashed.
The dishwasher will not drain.		The sink spigot is blocked.	Clean out the sink spigot.
- continuous flashing of the
	light of the running programme	The water drain hose has not been	Check the water drain hose
-	appears in the digital	correctly laid or it is bent or	connection.
		squashed.
	display
- continuous flashing of the		Anti-flood device is activated.	Close the water tap and
	light of the running programme		contact your local Service
			Force Centre.

- appears in the digital display

	The dishwasher door has not been	Close the door
	properly closed.
The programme does not start.
	The main plug is not plugged in.	Insert the mains plug
	The fuse has blown in the household	Replace the fuse.
	fuse box.
	Delay start has been selected	If dishes are to be washed
		immediately, cancel the delay
		start.

19