Zanussi ZDF 501 user manual Installation, Water connection

Page 23

Installation

WARNING!

Any electrical and/or plumbing work required to install this appliance should be carried out by a qualified electrician and/or plumber or competent person.

Water connection

WARNING!

The dishwasher must not be connected to open water appliances or instantaneous water heaters. This dishwasher may be fed with either hot (max. 60°) or cold water. Nevertheless we advise you a cold water supply.

CAUTION!

WARNING!

Only use, for connection to the water mains, new hose-set; old hose-set must not be reused.

If the machine is connected to new pipes or pipes which have not been used for a long time, you should run the water for a few minutes before connecting the inlet hose.

Inlet hose

Connect the inlet hose to a water tap with an external thread of 3/4”.

The inlet hose can be turned either to the left or the right to suit the installation by means of the locknut.

The locknut must be correctly fitted to avoid water leaks.

Drain hose

-Connect drain hose to the sink. Secure it with the supplied hose clamp.

-Required height: 30 to 100 cm above bottom of the dishwasher.

-If you use a drain hose extension the total length should not be longer than 4 metres. Likewise the internal diameter of the couplings used for connections to the waste outlet must be no smaller than the diameter of the hose provided.

23

Image 23

Contents User Manual Dishwasher Content All packaging must be removed before use Safety informationDo not sit or stand on the open door On/Off button Delay start button Salt and rinse aid lightsControl panel and functions Programme in progress lightStarting the washing programme Cancel the washing programme in progressFunction buttons Programme selectionLight Delay startCancel the delay start in progress Salt refillingAuto washing programme Programme tableFill up the salt and rinse aid container When using tablets that integrate rinse aid and detergentAdjust the rinse aid dosage Before the first useWater softener is factory set at position Setting the water softener manually see tableSetting the water softener electronically see table Use only special salt suitable for dishwashers Filling with dishwasher saltFilling with rinse aid Adjusting the dosage of rinse aidFollowing items are not suitable for use in the dishwasher Loading cutlery and dishesIf plates are to be loaded in the upper basket Never lift or lower the basket on one side only Adjusting the height of the upper basketTo move to the higher position proceed as follows Unloading the dishwasher Filling with detergentNever try to remove the spray arms Cleaning and careCleaning the filters Prolonged periods of non-operation Environmental concernsDishwasher will not start or stops during operation Something not working Wash results are not satisfactory Rinse and Hold Technical dataConsumption values 30 min EcoFull load Hints for test institutesWater connection InstallationElectrical connection Levelling Fitting under a counterMajor Appliances Service and spare parts08705 Customer Care DepartmentExclusions Guarantee conditionsThis guarantee does not cover European guarantee LU4 9QQ Page Page 156999 58/0 Subject to change without notice