Sherwood RX-772 manual Input Selector KNOB/BUTTONS

Page 10

1.POWER SWITCH

Push this switch to enter the standby mode. To switch the power off, push again this switch.

2.POWER ON BUTTON

In the standby mode, when this button is pressed, the unit is turned on to enter the operating mode.

When the BAND button on the front panel is pressed, the unit is turned on, too.

3.STANDBY BUTTON

In the operating mode, when this button is pressed, the unit is turned off to enter the stnadby mode.

4.STANDBY INDICATOR

5.HEADPHONE JACK

Stereo headphones with a standard 1/4 inch plug can be plugged into this jack for private listening.

6.INPUT SELECTOR KNOB/BUTTONS

Rotate the INPUT SELECTOR knob or press the button to select the desired input source.

7.BAND BUTTON

Each time this button is pressed, the band changes as follows.

FM STEREO FM MONO AM

8.SPEAKER A, B SELECTOR BUTTONS/INDICATORS These buttons allow you to select various combinations of speakers as follows:

To drive A speakers, press only the SPEAKER A but- ton ("A" indicator lights up).

To drive B speakers, press only the SPEAKER B but- ton ("B" indicator lights up).

To drive both A and B speakers, press the SPEAKER A and B buttons.("A" and "B" indicators light up).

When using headphones for private listening, press these buttons to switch off the speaker A and B ("A" and "B" indicators go off).

9.DIMMER BUTTON

Press this button to select the brightness of the fluorescent displays as desired.

Each time this button is pressed, the brightness of all fluorescent displays of this unit and Sherwood CD player shch as CD-772, etc. connected by the DIGI LINK changes together as follows:

ON dimmer OFF

10.SLEEP BUTTON

Press this button to activate the sleep timer for a specified period of time.

Each time this button is pressed, the sleep time changes as follows:

10 20 30 ���� � 90 OFF

Unit : minutes

11.TONE BUTTON

Press this button to listen to a program source with the tone effect or not.

12.TREBLE UP/DOWN (/) BUTTONS Adjust the treble as desired with these buttons.

13.BASS UP/DOWN (/) BUTTONS

Adjust the bass as desired with these buttons.

14.VOLUME CONTROL KNOB, UP/DOWN ( /)

BUTTONS

Adjust the volume to a comfortable listening level with this knob or these buttons.

15.MUTE BUTTON

Press this button to temporarily mute the sound. Press again to resume the previous sound level.

16.MEMORY BUTTON

Press this button to store stations.

17.TUNING UP/DOWN (/▼, +/-) BUTTONS Press these buttons to tune in the desired stations.

18.PRESET UP/DOWN (/▼, +/-) BUTTONS

Press this button to select the preset stations.

19.PRESET SCAN BUTTON

Press this button to scan the stations in the preset sequence.

20.MODE BUTTON

Each time this button is pressed, the mode changes as follows :

SPEAKER (TONE : ON BASS TREBLE) or

BALANCE ( TONE : OFF)

21.SELECT KNOB

At the desired mode, rotate this knob to adjust it as desired.

22.FLUORESCENT DISPLAY

23.REMOTE SENSOR

24.RDS BUTTONS (Regional option for Europe, etc.) Use these buttons when listening to RDS broadcast. For more information, refer to pages 17~19.

25.CD PLAYER SECTION

- to stop play ■■ - to pause play - to begin play

REPEAT - to play a track, disc, etc. repeatedly REPEAT A/B - to play a specific part (A to B)repeatedly ■◀◀, ▶▶■ - to skip backward or forward

9

Image 10
Contents Page Page Introduction Read this Before Operating Your UnitListening to RDS Broadcasts FM only Remote Control Operation RangeRDS Tuner Regional Option for some countries in Europe, etc Connecting Antennas System ConnectionsConnecting Phono Connecting Video and Audio ComponentsConnecting Digi Link Connecting PRE Outs or Main INSConnecting Speakers Switched AC Outlet AC InputFront Panel & Remote Controls Front Panel Controls System Remote ControlsInput Selector KNOB/BUTTONS Remove the cover Load two batteries AAA size, 1.5 V matching the polarityOperations Standby mode, turn the power onSwitch the desired speakers on Listening to a Program SourceSelect the desired input source To listen with the headphonesTo mute the sound Listening in the desired tone mode Adjusting the modes as desiredWhen adjusting the Speaker mode Listening to Radio Broadcasts Auto tuningManual tuning Select the tunerPresetting radio stations Repeat the above steps 1 to 3 to memorize other stationsListening to RDS Broadcasts FM only FM mode, select the RDS search modeRDS Search FM mode, press the Search Mode button twice PTY SearchFM mode, press the Search Mode button three times TP SearchRecording with Tape RecordingRecording with Video Adjusting the brightness of the fluorescent displays Operating the sleep timerOther Functions Troubleshooting Guide Problem Possible Cause RemedySpecifications Amplifier Section