Sherwood RX-772 manual Listening to Radio Broadcasts, Auto tuning, Select the tuner, Manual tuning

Page 16

LISTENING TO RADIO BROADCASTS

Auto tuning

1. Select the tuner.

Band Frequency

2. Select the disired band.

• Each time this button is pressed, the band is changed as follows :

FM STEREO FM MONO AM

(" " lights up) (" " lights up)

• When FM stereo broadcasts are poor because of weak broadcast signals, select the FM mono mode to reduce the noise, then FM broadcasts are repro- duced in monaural sound.

• When pressing the BAND button or the TUNER button without selecting the tuner, the tuner will be selected automatically.

3. Press the TUNING UP/DOWN (/▼, +/-) buttons for more than 0.5 seconds.

• The tuner will now search until a station of sufficient strength has been found. The display shows the

tuned frequency and " " or " ".

• If the station found is not the desired one, simply repeat this operation.

• Weak stations are skipped during auto tuning.

Manual tuning

• Manual tuning is useful when you already know the frequency of the desired station.

• After selecting the tuner and the desired band, press the TUNING UP/DOWN (/, +/-) buttons repeatedly until the right frequency has been reached.

15

Image 16
Contents Page Page Introduction Read this Before Operating Your UnitListening to RDS Broadcasts FM only Remote Control Operation RangeRDS Tuner Regional Option for some countries in Europe, etc Connecting Antennas System ConnectionsConnecting Phono Connecting Video and Audio ComponentsConnecting Digi Link Connecting PRE Outs or Main INSConnecting Speakers Switched AC Outlet AC InputFront Panel & Remote Controls Front Panel Controls System Remote ControlsInput Selector KNOB/BUTTONS Remove the cover Load two batteries AAA size, 1.5 V matching the polarityStandby mode, turn the power on Switch the desired speakers onOperations Listening to a Program SourceSelect the desired input source To listen with the headphonesTo mute the sound Listening in the desired tone mode Adjusting the modes as desiredWhen adjusting the Speaker mode Auto tuning Manual tuningListening to Radio Broadcasts Select the tunerPresetting radio stations Repeat the above steps 1 to 3 to memorize other stationsListening to RDS Broadcasts FM only FM mode, select the RDS search modeRDS Search FM mode, press the Search Mode button twice PTY SearchFM mode, press the Search Mode button three times TP SearchRecording with Tape RecordingRecording with Video Adjusting the brightness of the fluorescent displays Operating the sleep timerOther Functions Troubleshooting Guide Problem Possible Cause RemedySpecifications Amplifier Section