Adjustable Temperature Control
The adjustable cold control is located on the top left side of the evaporator housing inside the unit. “5” is the medium (recommended) setting and “9” is the coldest setting.
NSF Certified Temperature Gauge
This appliance is equipped with an NSF certified temperature gauge to display cabinet internal temperature. The temperature gauge is located on the top right side of the evaporator housing inside the unit.
Fluorescent Lamp (Glass Door Models)
The Glass Door Refrigerator is equipped with a 17 watt fluorescent lamp. A ballast – lamp mismatch may result in poor or no lighting.
If the lamp fails, replace with a lamp of the same type and wattage. Also, replace a lamp that flickers continuously. This could damage the ballast.
Turning the light off, when not in use, will save energy. However, frequent
Use only NSF certified lamp which can be ordered from your Frigidaire Commercial Service Center by calling
Interior Light (Stainless Steel Door Models)
The Stainless Steel Door models are equipped with a 40 watt bulb that lights up when the door is opened. If the bulb goes bad, replace with bulb of the same type and wattage. This is a special bulb with a shatterproof coating. Use only an NSF certified bulb of the same type and wattage which can be ordered from your Frigidaire Commercial Service Center by calling
Other Features
•NSF Certified top mounted evaporator.
•2 ½ thick urethane foam cabinet insulation.
•Torsion spring door closer (Glass Door models).
•Stainless steel evaporator housing.
•Removable stainless steel drain cover.
•Heavy duty front grill.
•Heavy duty commercially rated electrical harness.
•Heavy duty removable stainless steel shelf supports.
Routine Maintenance
Cleaning the Interior
Be sure to turn the temperature control to “OFF” and unplug the electrical cord. Wash the inside surface of the storage area with warm water and baking soda solution (about one tablespoon of baking soda per quart of warm water). Rinse thoroughly with clean, warm water and wipe dry.
Cleaning the Exterior
Wipe the cabinet exterior occasionally with a cloth dampened in mild detergent and water. Rinse and wipe dry with a soft cloth. Do not use razor blades or other sharp instruments that can scratch the appliance surface when removing adhesive labels. Any glue left from the tape can be removed with a mixture of warm water and mild detergent or touch the residue with the sticky side of tape already removed. DO NOT REMOVE THE SERIAL PLATE.
Condensate Pan
Some models have a condensate pan in a fixed position located behind the toe grill. This must not be removed from under the cabinet. If the pan is removed, condensate will drop onto the floor.
POWER FAILURE
DO NOT open the appliance lid unnecessarily if the appliance is off for several hours.
If a power failure occurs, pack seven or eight pounds of dry ice into the appliance every 24 hours. Look in the Yellow Pages under “Dry Ice”, “Dairies”, or “Ice Cream Manufacturers” for local dry ice suppliers. Always wear gloves and use caution when handling dry ice.
6