PureSource TM*ice and Water Fi#er (some models)
NOTE:ifyoup"t°ha ar, frigeratorPut" So ut"'ceTM* I°eao.Waterf.tep ,oaseteathefo. .o inguse
and care informat!on. This ice and water filter SYStem tinters water to your ice maker and water dispenser. It is located in the upper right back corner of the fresh food compartment.
System Startup:
Water supply does not need to be turned off, however, do not use ice and water dispenser while installing filter. The filter cartridge has already been installed in the filter housing at the factory. Refer to the How The Water Dispenser Works section
to properly fill the system with water.
Order new filter cartridges through the dealer where you bought the refrigerator, contact the Customer Care Center at
The PureSoume TM * NGRG- 2000 Ice and Water Filter System with the
cartridge is tested and certified by NSF International, the nationally recognized and respected,
not for profit, certification organization for public health safety. The PureSource TM* system is tested and certified to ANSl/NSF Standard 42. See performance data sheet for specifications. This system should not be used on water that is microbiologically unsafe or with water of unknown quality unless the water has been adequately disinfected before or after traveling through the filtration system.
Rated Capacity - 400 gallons Rated service flow
Maximum Operating Temp. - 100° F
* White Westinghouse uses the name CrystaICbar
Changing the Filter:
Water conditions vary throughout the world, but changing the water filter every 6 - 9 months normally wiii ensure the highest possible water quality. The Filter Status light wiii turn red after 400 gallons of water has flowed through the ice and water dispenser (some models). Also, if the filter has been in a refrigerator that has not been in use for awhile (during moving for example), change the filter before reinstalling the refrigerator. The dispenser system will also operate without filtration (with filter cartridge removed).
To change fi#er:
It is not necessary to turn the water supply off to change the filter.
1.Open freezer door and leave open until filter change is complete.
2.Turn the ice maker's power switch to the Off ("0") position (See illustration on page 14).
3.Hold filter cup firmly, and unscrew towards left (Some water could
leak out as you remove cup. This is normal.). Filter cartridge should come down with cup. if cartridge remains in housing, pull down gently, while twisting filter back and forth.
4.Rinse out cup under running water.
5.The large
back in place, if the
6.Discard old filter cartridge.
7.Remove new filter cartridge from packaging and place in cup. The end with the small
8.Screw cup, with filter, back onto housing. Do Not Use Wrench To Reinstall Cup. Filter cartridge will
9.Turn the ice maker's power switch to the On ("1") position.
10.Check for leaks. Open refrigerator door. Wipe any water droplets from the filter cup. Fill a glass with water. If there is a leak, unscrew filter cup, and reinsert the filter cartridge. Check placement of large
11.To condition filter system and purge air from water line, fill a glass with water. Continue flushing the system for approximately 3 minutes to assure that the purest water possible is stored in the water tank.
After replacing the fiite[ cartridge, it w!il be necessary t0 press the Filter Status reset button located Onthe ice and water dispenser. This will reset
lights flash
On models without a Filter Status reset button, there is a set of Reminder Stickers !ncluded in the envelope that the Use & Care Manual
came in. Choose a dated sticker that indicates 6 _9 months (depending on your wate[ quaiity and usage) from the date of !nstallation, Place the sticker on the front of th÷ filter Cup to rem!nd you when !t !s time to change the filter,
instead of PureSource, but they are the same filter
16