Delivery Hose Pressurization

FIRST STEPS (continued)

•Open the CO2 canister valve all the way by turning counterclockwise until it stops. This valve seals at both the fully open and fully closed positions. Failure to completely open or close the valve could result in premature loss of CO2 pressure.

•Open the regulator shut-off valve by moving it to the 6 o’clock position.

•Check gauge pressure. Adjust the Regulator Adjustment Screw as necessary until the pressure reads between 12 to 14 psi. Tighten the Adjustment Lock Nut.

KEGTO CABINET INSTALLATION

•Place the keg on the Support Shelf and push back next to

the CO2 canister (16) (See TIPS ON INSTALLING KEG TO THE CABINET) inside the cabinet as shown.

NOTE

Shelf tower has been removed for clarity.

TIPS ON INSTALLING THE KEG TO THE CABINET

WARNING

CO2 CANISTERTO CABINET INSTALLATION

•Remove adjustable shelf from inside of cabinet.

NOTE

The adjustable shelf is intended for use with 1/4 keg or no keg. Reinstall shelf after keg installion if using 1/4 keg.

•Lift and place the CO2 canister (16) with the CO2 regulator (10) behind the shelf tower inside of the CO2 canister bracket. It is important that the canister be kept in an upright position to operate efficiently.

SAFE KEG HANDLING

•Installing the keg to the cabinet is a two-person team effort. NEVER lift a full ½ keg alone. Doing so may cause severe injury.

•With the door fully open and the help of another person, lift the keg vertically on both sides until the keg is higher than the keg support shelf.

•Set the edge of the keg on top of the plastic protective plate located on top of keg support shelf. Slide the keg back until it is fully inside the cabinet.

•Care must be taken to avoid damage to the temperature control and shelf tower located in the cabinet.

NOTE

The above illustration does not show the tap installed for clarity of installation.