Door Removal / Reversal Instructions

Door Stop

Screw

Top		Bottom
Hinge
	Center	Hinge
Screw
	Hinge	Screw

	Screw

Screws

Top Hinge

Cabinet

Hole Plugs

Hinge

Hole Plug

Door Stop	Door
Screw	Stop
	Washer
	Shim
	Hinge Pin
	Center
	Hinge

DOOR REMOVAL AND REVERSAL INSTRUCTIONS:

NOTE

The direction in which your beverage center doors open (door swing) can be reversed, from left to right or right to left, by moving the door hinges from one side to the other. Reversing the door swing should be performed by a qualified person.

IMPORTANT

Before you begin, turn the beverage center temperature control to “0” and remove the electrical power cord from the wall outlet. Remove any food from door shelves.

1.	Remove toe grille.
2.	Remove top hinge with 3/8” hex driver and lift freezer door off of center
	hinge pin. Set door aside.
3.	Unscrew center hinge pin using adjustable wrench and save for
	reassembly. Ensure plastic washer stays on hinge pin.
4.	Lift refrigerator door off of bottom hinge and set aside.
5.	Remove center hinge and shim by removing inside screw and
	loosening two outside screws enough to allow hinge and shim to slide out.
	Tighten screws.

Hinge

Screws

6. Loosen two outside screws on opposite side of refrigerator, remove inside

Hole PlugHandle Hole Plugs

	screw and install center hinge.
7.	Remove two screws on bottom hinge with 3/8” socket wrench.
8.	Install bottom hinge on opposite side with the two screws removed from
	step 7.
9.	Unscrew bottom hinge pin using adjustable wrench. Move hinge pin to
	other hole in hinge and tighten with adjustable wrench.
10.	Move beverage center door stops to opposite side. Before starting screws,
	use an awl to puncture the foam.
11.	Position beverage center door onto bottom hinge pin and screw center
	hinge pin through center hinge into top of door. Close beverage center
	door to help align hinge hole.
12.	Tighten center hinge pin with adjustable wrench.
13.	Remove cabinet and hinge hole plugs and move to opposite side.
14.	Lower freezer door onto center hinge pin.
15.	Close freezer door. Have an assistant lift up on opposite side of door while
	tightening screws to install top hinge.
16.	Replace toe grille.
17.	Plug in electrical power cord and turn beverage center temperature
	control to the “5” position. Adjust setting as necessary.