CARE & CLEANING (continued)
PROPER CLEANING OF BEVERAGE CENTER DISPENSING SYSTEM
Your beverage center’s beverage dispensing system needs regular cleaning and sterilization in order to continue serving draft beer with its pure brewery flavor. It is recommended that the delivery lines be cleaned weekly and the entire delivery system cleaned before a new keg is attached. This is a relatively simple task. You will need the following parts to clean your unit’s dispensing system. These parts are available at any draft beer dispensing equipment supplier or call Electrolux Consumer Services at
(A)1 Quart Plastic Cleaning Bottle
(B)Low Profile Hand Pump
(C)Solid Brass Faucet Cleaning Attachment
(D)4 oz. Bottle of Cleaning Solution
(E)Faucet Wrench
(F)Faucet Cleaning Brush
•Mix one gallon of warm water with one ounce of the cleaning solution in a bucket.
•Remove the bottle cap and fill the bottle with the solution. Replace the cap. Do not discard the remaining solution.
•Before removing the delivery line from the tap or from the coupler, make sure the remaining beverage in the delivery line is blown out. This can be done by quickly opening and closing the regulator outlet valve.
•Remove the coupler from keg by rotating it counterclockwise.
•Remove the braided hose (gas line) from the coupler. Make sure the canister valve and regulator
•Remove the faucet from the shank assembly by turning the threaded stainless steel collar clockwise using a faucet wrench.
•Disassemble the faucet parts and place in the cleaning solution bucket.
•Attach the brass attachment on the end of the cleaning hose to the faucet shank assembly by turning the stainless steel collar counterclockwise. Tighten the collar slightly.
faucet wrench and tightening it slightly. DO NOT over tighten the collar.
•Reattach the braided hose (gas line) to the keg coupler and open both the canister valve and regulator
•Reattach the keg coupler to the keg. Refer to Coupler to Keg Installation procedures.
•Remove the sump and drip tray from the door and clean thoroughly. Refer to Cleaning and Maintenance Guide.
•Reinstall the sump and drip tray to the door. Refer to Sump and Drip Tray Assembly Installation procedures.
NOTE
Read and follow the instructions that come with the cleaning kit before cleaning your beverage cooler.
NEVER CLEAN CONDENSER (SOME MODELS)
If your beverage center is equipped with a Never Clean condenser, there’s no need to clean the condenser under normal operating conditions. If the beverage center is operated under particularly dusty or greasy conditions, or if there is significant pet traffic in your home, it may be necessary to periodically clean the condenser for maximum efficiency.
Defrost Water Pan (some models)
•If the coupler has a shutoff, make sure it is in the open position.
•Place the keg coupler in the cleaning solution bucket and pump the cleaning solution through the beer line.
•Clean the faucet parts and keg coupler thoroughly using the faucet cleaning brush. Also, use the faucet cleaning brush to clean around the shank and coupling.
•Rinse all the parts with cool fresh water and reassemble the faucet.
•Detach the cleaning solution bottle from the faucet shank by turning the threaded stainless steel collar clockwise. Rinse the bottle with cool fresh water.
•Fill the bottle with fresh water and
•Disconnect the cleaner and reinstall the faucet to the shank by turning the collar counterclockwise using a
18