Frigidaire RH30WC60GS, EI36WC60GS Electrical & Installation requirements, Electrical requirements

Page 5

Important safety Instructions - Electrical & Installation

5

requirements

READ AND SAVE THESE INSTRUCTIONS

 

Electrical & Installation requirements

 

Electrical requirements

IMPORTANT

Observe all governing codes and ordinances.

It is the customer’s responsibility:

To contact a qualified electrical installer.

To assure that the electrical installation is adequate and in conformance with National Electrical Code, ANSI/NFPA 70 — latest edition*, or CSA Standards C22.1-94, Canadian Electrical Code, Part 1 and C22.2 No.0-M91 - latest edition** and all local codes and ordinances.

If codes permit and a separate ground wire is used, it is recommended that a qualified electrician determine that the ground path is adequate.

Do not ground to a gas pipe.

Check with a qualified electrician if you are not sure range hood is properly grounded.

Do not have a fuse in the neutral or ground circuit.

IMPORTANT

Save Installation Instructions for electrical inspector’s use.

The range hood must be connected with copper wire only.

The range hood should be connected directly to the fused disconnect (Or circuit breaker) box through metal electrical conduit.

Wire sizes must conform to the requirements of the National Electrical Code ANSI/NFPA 70 — latest edi- tion*, or CSA Standards C22.1-94, Canadian Electri- cal Code Part 1 and C22.2 No. 0-M91 - latest edi- tion** and all local codes and ordinances.

A U.L.- or C.S.A.-listed conduit connector must be provided at each end of the power supply conduit (at the range hood and at the junction box).

Copies of the standards listed may be obtained from:

*National Fire Protection Association Batterymarch Park Quincy, Massachusetts 02269

**CSA International 8501 East Pleasant Valley Road Cleve- land, Ohio 44131-5575

Before installing the hood

1.For the most efficient air flow exhaust, use a straight run or as few elbows as possible.

Vent unit to outside of building, only.

2.At least two people are necessary for installation.

3.The hood is fitted with Screws and Drywall Anchors suitable for most surfaces, consult a Qualified Installer, check if they perfectly fit with your cabinet/wall.

4.Do not use flex ducting.

5.COLD WEATHER installations should have an additional backdraft damper installed to minimize backward cold air flow and a nonmetallic thermal break to minimize conduction of outside temperatures as part of the ductwork. The damper should be on the cold air side of the thermal break.

The break should be as close as possible to where the ducting enters the heated portion of the house.

6.Make up air: Local building codes may require the use of Make-Up Air Systems when using Ducted Ventilation Systems greater than specified CFM of air movement.

The specified CFM varies from locale to locale. Consult your HVAC professional for specific requirements in your area.

Page 4 Page 6
Image 5
Page 4 Page 6
Contents Installation, Use & Care Guide Please read and save this guide Table of contentsKeep a record for quick reference Questions?Important Safety Instructions Read and Save These Instructions Electrical requirements Electrical & Installation requirementsList of Materials Optional accessoriesParts Included with your Hood Tools/Materials requiredInstalling preparation Installing the hoodWall framing for adequate support Removing the packagingExamples of possible ducting Ductwork installation guidelinesDuctwork and wiring locations Mounting the duct cover bracket House wiring locationCeiling ducting Wall ductingIMPORTANT- Framing must be capable of supporting 100 lbs Install framing for hood supportMounting the hood Installing the hood Air deflector installation Recirculating accessories Connecting the ductworkMounting the glass canopy Making the electrical connections120 VAC, 15 or 20 Amp circuit required Failure to do so can result in death or electrical shockMounting the duct cover Features Control buttons Special functions For Best results Filters Care and cleaningLights Cleaning Charcoal filter placement Recirculating accessoriesOptional Charcoal Filters Hood SurfaceElectrolux Home Products North America Exclusions This warranty does not cover the followingRESPONSIBILITIESresponsible for the items listed below

EI36WC60GS, EI30WC60GS, RH30WC60GS, 316488522, RH36WC60GS specifications

Frigidaire has long been recognized for its commitment to quality, innovation, and reliability in kitchen appliances. Among its wide range of products, the Frigidaire RH36WC60GS, RH30WC60GS, EI30WC60GS, and EI36WC60GS stand out as pinnacle offerings in the realm of wall-mounted range hoods. Each of these models delivers a blend of advanced features and technologies designed to enhance both functionality and aesthetics in the kitchen.

The RH36WC60GS model is a 36-inch professional-style wall hood that showcases Frigidaire’s trademark focus on performance and design. It comes with powerful ventilation capabilities, featuring a 600 CFM motor to effectively eliminate smoke, steam, and odors from cooking. This model operates at multiple speeds, allowing users to select just the right level of airflow for their cooking needs. Its sleek stainless-steel finish is not only visually appealing but also easy to clean, making it an ideal choice for modern kitchens.

Similarly, the RH30WC60GS is a 30-inch model that adopts the same high standard of engineering. It mirrors the robust performance characteristics of the larger RH36WC60GS but is designed to fit smaller spaces without compromising on efficiency. The unit is equipped with a dishwasher-safe grease filter, enhancing maintenance ease and ensuring long-lasting performance.

The EI30WC60GS and EI36WC60GS are additional offerings that further exemplify Frigidaire's innovative spirit. These models come with sophisticated technologies such as an advanced LED lighting system, which illuminates the cooking area while being energy-efficient. Both models also include a quiet mode feature to minimize noise pollution without sacrificing ventilation power, a key selling point for busy households.

All four hoods provide compatibility with Frigidaire’s proprietary air quality monitoring systems, allowing users to maintain an optimal cooking environment. Their sleek, contemporary designs seamlessly integrate with a variety of kitchen styles, ranging from traditional to ultra-modern.

In summary, the Frigidaire RH36WC60GS, RH30WC60GS, EI30WC60GS, and EI36WC60GS range hoods combine powerful ventilation, ease of maintenance, and modern aesthetics. These characteristics make them indispensable tools for any culinary enthusiast, ensuring clean air and a pleasant cooking experience. Whether in spacious gourmet kitchens or compact cooking spaces, these hoods stand ready to enhance the cooking environment.
Top Page Image Contents