List of Materials

Parts included in your hood

•4 - 0.45 x 1.3 cm mounting screws

•2 - .35 x .65 cm rectangular vent transition mounting screws

•2 - .29 x .65 cm round metal mounting plate mounting screws

•3¼” x 10” (8.3 x 25.4 cm) rectangular metal vent system.

•7” (17.8 cm) round metal mounting plate.

Parts Needed

•2 - UL listed wire connectors

•Wall or roof cap with damper to match vent system

•Vent clamps/duct tape as required

•UL listed or CSA approved ½” strain relief

Tools/Materials required

•Drill

•1¼” (3.0 cm) drill bit

•⅛” (0.3 cm) drill bit for pilot holes

•Pencil

•Wire stripper or utility knife

•Tape measure or ruler

•Caulking gun and weatherproof caulking compound

•Flat-blade screwdriver

•Phillips screwdriver

•Saber or keyhole saw

For cabinets with recessed bottoms:

•Two - 2” (5.1 cm) wide filler strips. Length and thickness determined by recess dimensions.

•Four flat head wood screws or machine screws with washers and nuts (to attach filler strips).

LIST OF MATERIALS

ELECTRICAL REQUIREMENTS

Observe all governing codes and ordinances.

Ensure that the electrical installation is adequate and in conformance with National Electrical Code, ANSI/NFPA 70 (latest edition), or CSA Standards C22.1-94, Canadian Electrical Code, Part 1 and C22.2 No. 0-M91 (latest edi- tion) and all local codes and ordinances.

If codes permit and a separate ground wire is used, it is recommended that a qualified electrician determine that the ground path is adequate.

A copy of the above code standards can be obtained from:

National Fire Protection Association

One Batterymarch Park

Quincy, MA 02269

CSA International

8501 East Pleasant Valley Road

Cleveland, OH 44131-5575

•A 120 volt, 60 Hz., AC only, 15-amp, fused electrical circuit is required.

•If the house has aluminum wiring, follow the procedure below:

1.Connect a section of solid copper wire to the pigtail leads.

.Connect the aluminum wiring to the added section of copper wire using special co nectors and/or tools designed and UL listed for joining copper to aluminum.

Follow the electrical connector manufacturer’s recom- mended procedure. Aluminum/copper connection must conform with local codes and industry accepted wiring practices.

•Wire sizes and connections must conform with the rating of the appliance as specified on the model/serial rating plate.

The model/serial plate is located on the left side of the range hood.

•Wire sizes must conform to the requirements of the National Electrical Code, ANSI/NFPA 70 (la est edition), or CSA Standards C22. 1-94, Canad an Electrical Code, Part 1 and C22.2 No. 0-M91 (latest edition) and all local codes and ordinances.