Frigidaire LI30MB manual Location Requirements, Product Dimensions, For Mobile Home Installations

Page 6

LOCATION REQUIREMENTS

IMPORTANT

Observe all governing codes and ordinances.

It is the installer’s responsibility to comply with installation clearances specified on the model/serial rating plate. The model/serial rating plate is located inside the range hood on the left side (See page 2 for location). Range hood location should be away from strong draft areas, such as windows, doors and strong heating vents.

Cabinet opening dimensions that are shown must be used. Given dimensions provide minimum clearance. Consult the cooktop/range manufacturer installation instructions before making any cutouts.

Grounded electrical outlet is required. See “Electrical Requirements” section.

All openings in ceiling and wall where canopy hood will be installed must be sealed.

For Mobile Home Installations

The installation of this range hood must conform to the Manufactured Home Construction Safety Standards, Title 24 CFR, Part 328 (formerly the Federal Standard for Mobile Home Construction and Safety, Title 24, HUD, Part

280)or when such standard is not applicable, the stan- dard for Manufactured Home Installation 1982 (Manu- factured Home Sites, Communities and Setups) ANSI A225.1/NFPA 501A, or latest edition, or with local codes.

Cabinet Dimensions

B

C

A

D

A. 66” (167 cm) suggested min. - top of range hood to floor. B. 30” (76.2 cm) min. cabinet opening width for 30” (76.2 cm) models and 36” (91.4 cm) min. cabinet width for 36” (91.4 cm) models.

C. 13” (33.0 cm) cabinet depth

D. 36” (91.4 cm) base cabinet height

PRODUCT DIMENSIONS

 

DIM B

 

 

7/8

 

 

(2.2cm)

10” (25.4cm)

 

9/16

 

(1.4cm)

9½” (24cm)

 

 

recirculating cover

 

 

7” (17.8cm

 

 

1½” (4cm)

 

 

recirculating cover

415/16

7/8

 

(12.5cm)

(2.2cm)

 

 

3¼” (8.25cm)

DIM A

1½” (3.8cm)

193/4

 

 

typical both sides

(50.2cm)

hood model

 

Dim A

Dim B

 

 

 

 

FHWC3040

30”

(76.2 cm)

69/16” (16.7 cm)

30” models

 

 

 

 

 

 

 

FHWC3640

36”

(91.44 cm)

9½” (24.3 cm)

36” models

 

 

 

 

 

 

 

1” (2.5cm)

typical both sides

9” (22.9cm)

typical both sides



Image 6
Contents USA Canada LI30MB Feb/13 Product Record and Registration Contents Important Safety Instructions Read all instructions before using this applianceFire Department List of Materials List of Materials Electrical RequirementsCabinet Dimensions Product DimensionsFor Mobile Home Installations Location RequirementsMakeup Air Cold Weather InstallationsVenting Requirements Venting MethodsDetermine Wiring Hole Location Prepare the LocationWall Venting To wire through topTo wire through wall Style 1 Recirculating Hood versionInstall Range Hood Ducted version Install Vent SystemInstalling the Hood Vent Connector InstallationPower Supply Cable Installation Electrical Shock Hazard Disconnect power before servicing Complete InstallationMake Electrical Connection Do not reconnect power until the installation is complete Recirculation Vent Cover