Frigidaire 318205317 To Start the Self-Clean Cycle, To Set the Controls for a Self-Clean Cycle

Self-cleaning

To Start the Self-Clean Cycle

*We recommend a 2 hour self-clean cycle for light soils, and a 3 hour cycle for average to heavy soils (to assure satisfactory results).

To Set the Controls for a Self-Clean Cycle:

1.Be sure the clock shows the correct time of day.

2.Push the CLEAN pad. "- - -" appears in the display.

3.Push the UP ARROW pad until "3:00" appears in the display for a 3 hour cycle, or push the DOWN ARROW pad until "2:00" appears in the display for a 2 hour cycle.

4.As soon as the UP or DOWN ARROW pad is released, "CLn" appears in the display.

5.As soon as the controls are set, the motor driven lock will begin to close automatically and the "Door

Locked" indicator light will flash. DO NOT open the door while the light is flashing (it takes about 15 seconds for the lock to close).

6.The "Door Locked" light will glow until the cleaning cycle is completed or cancelled, and the oven temperature has cooled.

When the Self-Clean Cycle is Completed:

1.The time of day will appear in the display window and the "Door Locked" light will continue to glow.

2.Once the oven has cooled down for about 1 hour and the "Door Locked" light has gone out, the oven door can be opened.

Stopping or Interrupting a Self-Cleaning Cycle

If it becomes necessary to stop or interrupt a self- cleaning cycle due to excessive smoke or fire:

1.Push the CLEAR OFF pad.

2.Once the oven has cooled down for about 1 hour and the "Door Locked" light has gone out, the oven door can be opened.

3.Correct the condition which caused the smoking.

4.Restart the self-clean cycle once all conditions have been corrected.

CAUTION

Use care when opening the oven door after self-clean- ing cycle. Stand to the side of the oven when opening the door to allow hot air or steam to escape.

DO NOT force the oven door open. This can damage the automatic door locking system. Use caution when opening the door after the self-cleaning cycle is com- pleted. The oven may still be VERY HOT.

Failure Modes

All failure modes give a visual and audible alarm. When display shows F10 (temperature runaway), F30 (oven sensor circuit fault) or F90 (motor door lock fault), the electronic oven control has detected a fault condition. Note that code and push the CLEAR OFF pad to clean the display and stop the beeping. Reprogram the oven. If fault recurs, push CLEAR OFF pad, disconnect the appliance to prevent damage and contact an authorized servicer.