Delay Start, Status Indicator Lights

750 Series

Operating Instructions

Vent

Latch

Very Important

Information— Read Before

Operating Your Dishwasher!

Normal Operating

Sounds

This dishwasher does not sound like most dishwashers—IT’S QUIETER!

Your dishwasher uses energy efficient motors for the wash and drain portions of the cycle you select. Each cycle has a series of water fills and drains for washing and rinsing dishes. As each cycle begins, you may–or may not–hear the drain motor.

The next sound you will hear is the splashing water as it enters the tub. Then the lower arm rotates and circulates water. This is followed by a pause and a slightly different sound as the upper arm sprays water. If you listen closely, you will hear the change in sound as the wash action switches from one arm to the other.

PLEASE BE ADVISED: If you compare this dishwasher to previous models, you may be surprised at what you DON’T hear!

Getting Started

1.Load dishwasher (See Preparing and Loading Dishes).

2.Add detergent (See Dishwasher Dispenser

&Detergents).

3.Add rinse aid, if needed (See Rinse Aid).

4.Turn dial clockwise to select cycle (See Cycle Chart) or number of hours for delay start.

5.Select desired energy OPTIONS (See Energy Options). The indicator will show red when selected.

6.If using DELAY START, go to step number 8.

7.Run hot water faucet nearest dishwasher until water is hot. Turn water off.

8.To start, close door to latch.

Delay Start

Allows you to delay starting the POTS & PANS cycle up to 6 hours.

•Turn dial to select number of hours.

•Select HI-TEMP WASH ON option and other desired options.

•Close door to latch. The DELAY START light will come on.

Status Indicator Lights

When DELAY START option is selected, the Delay Start light will glow as timer counts down to begin cycle.

The HEATING DELAY light means the cycle is being extended to heat water to proper temperature in the main wash or final rinse, based on options selected.

CLEAN light comes on when a cycle is complete. To turn it off, turn dial slightly until light goes off.