Electrolux Gas hob manual Something not working, SymptonSolution

Page 19

Something not working

If the hob is not working correctly, please carry out the following checks before contacting your local AEG Service Force Centre.

IMPORTANT: If you call out an engineer to a fault caused by incorrect use or installation, a charge will be made even if the hob is under guarantee.

Sympton:Solution

There is no spark when lighting the gas

Check hob is connected to the electricity supply. Check the fuse and replace if necessery.

When the operating knob is released the gas ring goes out again

The operating knob has not been depressed long enough, or has not been depressed sufficiently.

The gas ring burns unevenly

Ensure the cover has been replaced

 

correctly, e.g. after cleaning.

If after all these checks, your hob still does not operate correctly, contact your local AEG Service Force Centre.

In-guarantee customers should ensure that the above checks have been made as the engineer will make a charge if the fault is not a mechanical or electrical breakdown.

Please note that it will be necessary to provide proof of purchase for any in- guarantee service calls.

19

Image 19
Contents INSTRUCTION- and Installation Book Your New Appliance Table of contents Safety information Air intake Description of the productBurner markings OperationsPanel markings Ignition electrode a Burner cover/inner burner ring/outer burner ringThermo couple B Ignition Maintenance and cleaning Ceramic glass Stainless steel surfacesDo not use any kind of scouring powder ThegasburnerTechnical data Important safety requirements Pressure test Cut-out measurements MountingHeadroom FixingInstallation in work tops with a base unit underneath Do not install the hob above drawers Mm Cooker hood 290 mm Unit´s externally measured length580 mm Something not working SymptonSolutionCustomer Care Service & spare parts08705 929 Help us to help youGuarantee conditions Sweden FranceGermany ItalyPage 325 88-1620 Rev