Electrolux Gas hob manual Mounting, Headroom, Fixing, Cut-out measurements

Page 15

Mounting

Caution: In order to avoid a hazard this appliance must be installed according to these instructions for installation

The hob unit can be mounted in any type of kitchen with a table surface whose thickness is between 28 mm and 40 mm.

Headroom

The distance to any shelves or tops of a cabinet under the hob is to be at least 47 mm.

Fixing

Screw the fixing brackets out to such an extent that they can be turned in under the table top. Tighten the brackets on to the table top with an ordinary screwdriver.

Cut-out measurements

One rectangular hole is sawn out for the hob combination chosen.

The depth of the cut-out for any unit is: 490 mm

Length of hole = sum of all units` externally measured length, less 20 mm.

Minimum distance

Minimum distance

to side wall:

to rear wall (non-

150 mm

flammable material):

 

50 mm

Reinforcement beams

Mounting of Reinforcement Beams

A reinforcement Beam, with supporting flanges at each end, is included with each two-burner unit. For unit combinations, a reinforcement beam must be used between each unit.

15

Image 15
Contents INSTRUCTION- and Installation Book Your New Appliance Table of contents Safety information Air intake Description of the productOperations Burner markingsPanel markings Burner cover/inner burner ring/outer burner ring Ignition electrode aThermo couple B Ignition Maintenance and cleaning Ceramic glass Stainless steel surfacesDo not use any kind of scouring powder ThegasburnerTechnical data Important safety requirements Pressure test Cut-out measurements MountingHeadroom FixingInstallation in work tops with a base unit underneath Do not install the hob above drawers Unit´s externally measured length Mm Cooker hood 290 mm580 mm Something not working SymptonSolutionCustomer Care Service & spare parts08705 929 Help us to help youGuarantee conditions Sweden FranceGermany ItalyPage 325 88-1620 Rev