Electrolux Ceramic glass hob manual Child safety device

Page 13

Disconnection of AUTOMAX:

If you do not wish to use AUTOMAX, observe the following procedure:

1.Turn the control button to AOFF.

2.Then turn the control button to the required setting.

Setting the large zone on the double zones

1.Turn the control button to The display will show:

2.Then turn the control button to the required setting (e.g. setting 9).

If you wish to disconnect the large zone, turn off the zone and then turn the control button to the required setting.

Child safety device

Connection and disconnection of the child safety device is described in the section entitled “ Before use” .

When the child safety device is activated the display will show:

13

Image 13

Contents Instruction Book Your New Appliance Table of contents Safety information Control panel Description of the productCeramic glass surface Residual heat indicatorCooking zones Chec controlBefore use Connection of child safety device on zonesProtection of the glass ceramic surface Regulating Operating instructionsDouble cooking zone Residual-Heat indicator Autostop AutomaxRecommended settings when using Automax Child safety device Page Advice and hints for using the cooking zones Page Cleaning and maintenance Ceramic glass hob Stainless steel surfacesDo not stare at the heating units when in operation Clearance InstallationFixing Cut-out measurementsUnits externally measured length Electrical connection Single-phase zero-earthUnpacking Technical dataSomething not working Sympton SolutionProblems 08705 929 Service & spare partsGuarantee conditions France Page Page Page 325 88-1710 Rev