OPERATING COMPONENTS WITH REMOTE CONTROL 
1. Enter the setup code for each component other
than this receiver. For detalis, refer to “Entering a setup code” on page 18.
2. Turn on the component you want to operate.
3. Press the DEVICE button on the remote control
corresponding to the component you wish to operate.
4. Aim the remote control at the REMOTE
SENSOR of the component you wish to control and press the button corresponding to the operation you want.
LOADING BATTERIES
REMOTE CONTROL OPERATION RANGE
•Use the remote control within a range of about 7 meters (23 feet) and angles of up to 30 degrees aiming at the remote sensor.
ENGLISH
�When the remote control does not operate, the old batteries should be replaced. In this case, load new batteries within several minutes after removing old batteries.
�If the betteries are removed or have been exhausted for a longer period of time, memorized contents will be cleared. Should this happen, you should memorize them again.
1. Remove the cover.
+ 
2. Load two batteries (“AAA” size) matching the
polarity.
+
+ 
•Remove the batteries when they are not used for a long time.
•Do not use the rechargeable batteries
•Be sure to use alkaline batteries.
17