Surface elements and drip bowls

CAUTION

•Make sure drip bowls are in place - Absence of these bowls during cooking may subject wiring or components underneath to damage.

•Never immerse a surface element in water.

•Be sure the range is cool before removing surface elements or drip bowls. Be careful not to bend terminal ends when replacing surface elements after cleaning.

•Protective liners—Do not use aluminum foil to line surface drip bowls, or reflector pans. Only use aluminum foil as recommended in this manual. Improper installation of these liners may result in risk of electric shock, or fire.

Surface elements may be unplugged and removed to make cleaning the drip pans easier. The surface elements clean themselves when they are turned on. Food spilled on a hot element will burn off. Food spilled on a COOL element may be cleaned with a damp cloth—any remaining soil will burn off the next time the element is used.

To remove the surface elements and drip bowls

1.Lift the edge of the drip bowl across from the terminal end. Lift the surface element and drip bowl together just enough to clear the cooktop.

2.While holding the drip bowl and surface element, gently pull the terminal end out from terminal plug. DO NOT remove hold down clip (if equipped) from the drip bowl.

Hold Element

down support clip

(if equipped)

Allow element support to rest on drip pan inside rim.

Terminal end

Terminal plug

Fig. 1

CARE & CLEANING

Cleaning dripbowls

Wash in hot, soapy water or in the dishwasher. Rinse and dry while still warm. Hard to remove, burned on soil can be removed by soaking the drip bowls for about 20 minutes in a lightly diluted liquid cleanser or a solution of ammonia and water (1/2 cup ammonia to 1 gallon of water). A nylon scrubber may be used after soaking. DO NOT use abrasive cleaners or steel wool, they will scratch the surface. Always rinse with clean water and polish dry with a soft cloth.

To replace drip bowls and surface elements

1.Slide the terminal end on the element through the opening in the drip bowl (See Fig. 1).

2.Align the element support to rest on the rim inside the drip bowl. If your drip bowl is equipped with a hold down clip, align the element support opposite the terminal end with the slot in the hold down clip, and snap into place.

3.After the element is positioned in the drip bowl, line up the terminal end with the terminal plug as shown.

4.Hold the surface element and drip bowl together as level as possible and firmly push the terminal end into the terminal plug. Make sure element terminal is seated properly into terminal plug. Make sure the surface element is level to reduce the hazard of pans sliding off the element.

CAUTION

•When lowering the lift-up range cooktop, grasp the sides with finger-tips only. Be careful not to pinch fingers. DO NOT drop or bend the range cooktop when raising or lowering. This could damage the cooktop surface.

Fig. 2

To raise the cooktop for cleaning

1.Grasp the sides and lift from the front (See Fig. 2). Lift-up rods will support the top in a raised position. Only lift the top far enough to allow the support rods to snap into place.

2.Clean underneath using a clean cloth and hot, soapy water

3.To lower the top, gently push back on each rod to release the notched support. Hold the range top and slide the lift rods down into the range frame.