Electric installation

05. Leave at least 80 to 85 cm

between the top of the gas range

and any cabinet or range hood

install above the product. This gas

range is not prepared to be

For your safety, check the electric conditions of the place where the gas range will be installed by a qualify electrician or contact an authorize service.

ENG

installed built in.

06.Leave enought room between the back of the oven and the wall, to allow for opening the cover.

07.If the oven is installed next to a wooden wall, please place a fire- resistant panel next to the wall and ensure that the oven is more than 4 cm from the wall. Please place 1pc fire-resistant panel (lenght and a high degree are more than 4 cm than the oven ) between the wall and the oven, if the oven will be installed on wooden wall.

08.Make sure not to block the oven gas exit, including the funnel or the gas vents, when you install the oven.

Backsplash assembling (only in some

models)

Backsplash is packed inside the oven cavity. Unpack the backsplash and stand it on assembled position. Fix backsplash with 3 screws on each side as image shows.

80 to 85 cm

2 cm

Attention

The guarantee does not cover the problems caused by defective installations or changes that were performed by non-qualified

01.Before turning on the range, check to see if the voltage of the outlet to be used is the same as that indicated on the tag located close to the plug (along the power cord) or on the gas range identification label.

02.Install the ground cable or your gas range according to your local requirements.

03.If you need to modify the electric installation, this should be performed by qualified personnel.

04.Be sure that electric plug is easy to reach after installation.

05.Power cord should never be in contact with hot parts of the gas range, because the plastic protection might melt causing a short circuit.

06.Connect the range to its own outlet. Do not use an extension cord or adaptor plug.

07.Never ground the appliance on PVC or gas pipes.

08.Be sure that the power cord does not goes through the back of the gas range.

Attention

If you have any doubt, please contact a qualified person.

Do not modify your gas range plug.

Do not bite, twist or tie the power cord.

It is dangerous to modify the range specifications or features.

ENG