Frigidaire 316000641 manual Before Setting Oven Controls

Page 11

Before Setting Oven Controls

Arranging Oven Racks

ALWAYS ARRANGE OVEN RACKS WHEN THE OVEN IS COOL (PRIOR TO OPERATING THE OVEN). Always use oven mitts when using the oven.

Oven Vent Location

The oven vent is located below the backguard. When the oven is on, warm air is released through the vents. This venting is necessary for proper air circulation in the oven and good baking results.

REMOVING & REPLACING

OVEN RACKS

To remove, pull the rack forward until it stops. Lift up front of rack and slide out. To replace, fit the rack onto the guides on the oven walls. Tilt the front of the rack upward and slide the rack back into place.

ARRANGING OVEN RACKS WITH

5 RACK POSITIONS

To bake on 1 rack, place the rack on position 3 or 4. To bake on 2 racks, place the racks on positions 2 and 4.

Setting Oven Controls

Note: The oven function will not work if the time of day clock is not set. (Figure 2 Only)

To Set or Change the Temperature for Normal Baking

The oven can be programmed to bake at any temperature from 170°F to 550°F (65°C to 287°C).

To Set the Controls for Normal Baking:

1.Push BAKE. "— — —" appears in the display.

2.Within 5 seconds, push the UP or DOWN ARROW. The display will show "350°F (177°C)." By holding the UP or DOWN ARROW, the temperature can then be adjusted in 5°F (1°C) increments.

3.As soon as the UP or DOWN ARROW is released, the oven will begin heating to the selected temperature. When the displayed temperature reaches the desired baking temperature, the control will beep 3 times.

4.To cancel the baking function, push CANCEL.

To Change the Oven Temperature after Baking has Started:

1.If you are using the minute timer, push BAKE and make sure the bake temperature is displayed.

2.Push the UP or DOWN ARROW to increase or decrease the set temperature.

11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Page Product Registration ContentsImportant Safety Instructions Electric ignition models only Grounding InstructionsFor a silent control panel Temperature conversionControl Pad Functions Oven can be programmed toTo Set the Clock Setting the Clock and Minute TimerTo Set the Minute Timer Flame Size Type of Cooking Proper Burner AdjustmentsFlame Size Surface BurnersTo operate the surface burner ControlsDownward Position Before Setting Warmer Drawer ControlsIf equipped Arranging Warmer Drawer Rack Positions Upright PositionTo Operate the Warmer Drawer Setting Warmer Drawer ControlsIndicator Light Temperature SelectionSetting Oven Controls Before Setting Oven ControlsOnce the Controls are Set To Set the Automatic Timer Timed Bake FeatureWhen the Set Bake Time Runs Out Push Vari Broil To BroilRack Position From Top Food Adhere to the following cleaning precautions Oven CleaningSelf-Cleaning Oven Stopping or Interrupting a Self-Cleaning CycleWhen the Self-Clean Cycle is Completed To Start the Self-Clean CycleTo Set the Controls for a Self-Clean Cycle Cleaning Various Parts of Your Range General CleaningTo Clean the Burner Base and Gas Opening To Clean the CooktopTo Clean the Contoured Well Areas To Remove the Burner Cap AssemblyTo Remove and Replace Warmer Drawer some models To Remove and Replace Oven DoorTo Change the Oven Light some models To Clean the Spice Rack some modelsChanging Cooktop and/ or Oven Lights To Change the Cooktop Light some modelsTo Adjust Oven Temperature Adjusting Oven TemperatureOccurrence Possible CAUSE/SOLUTION Avoid Service ChecklistOven does not operate Page Range Warranty OL0037.PM5 AS0030.PM5
Top Page Image Contents