Frigidaire 316000635 manual Before Setting Oven Controls, Oven Vent Location, Arranging Oven Racks

Page 8

Before Setting Oven Controls

Oven Vent Location

The oven is vented under the left rear surface element. When the oven is on, warm air is released through the vents. This venting is necessary for proper air circulation in the oven and good baking results.

Arranging Oven Racks

(Some models may have one rack.) ALWAYS ARRANGE OVEN RACKS WHEN THE OVEN IS COOL (PRIOR TO OPERATING THE OVEN). Always use oven mitts when using the oven.

REMOVING &

REPLACING OVEN RACKS

To remove, pull the rack forward until it stops. Lift up front of rack and slide out. To replace, fit the rack onto the guides on the oven walls. Tilt the front of the rack upward and slide the rack back into place.

ARRANGING OVEN RACKS WITH

5 RACK POSITIONS

To bake on one rack, place the rack on position 3 or 4. To bake on two racks (some models), place the racks on po- sitions 2 and 4.

8

Image 8
Contents 316000635 Contents Product RegistrationImportant Safety Instructions Important Safety Instructions Start Indicator LIGHT-Flashes as Control Pad FunctionsOven can be programmed to UP and Down ArrowSetting the Clock and Minute Timer To Set the Minute TimerPush Timer ON/OFF To Change the Minute Timer while it is in useTypical Knob Setting Surface ControlsTo Operate the Surface Element Arranging Oven Racks Before Setting Oven ControlsOven Vent Location Setting Oven Controls To Set or Change the Temperature for Normal BakingTo Change the Oven Temperature after Baking has Started If the Power is Interrupted During a Bake CycleFor a Delayed Start Time and Automatic Shut-Off To Set the Automatic Timer Timed Bake Feature, OnlyWhen the Set Bake Time Runs Out To Begin Baking Immediately with an Automatic Shut-OffTo Broil Rack Position From Top FoodAdhere to the following cleaning precautions Oven CleaningSelf-Cleaning Oven To Start the Self-Clean Cycle Figure When the Self-Clean Cycle is Completed FigureStopping or Interrupting a Self-Cleaning Cycle or To Set the ControlsGeneral Cleaning Cleaning Various Parts of Your RangeTo Remove and Replace Oven Door To Raise the Top for CleaningSurface Elements and Drip Bowls Changing Cooktop and/or Oven Lights To Change the Cooktop Light some modelsTo Change the Oven Light some models Some modelsAdjusting Oven Temperature To Adjust Oven Temperature FigureEntire appliance does not operate Surface element too hot or not hot enoughSurface element does not heat Self-cleaning cycle does not work Soil not completely removed after self-cleaning cycleBroiling Poor baking resultsRange Warranty