GE LGB356, EGR2000, RGB744 manual Sealed Burner Assemblies on some models, For proper ignition

Page 28
After cleaning, make sure the slot in the burner head is positioned over the electrode.

CARE AND CLEANING

CAUTION: DO NOT OPERATE THE BURNER WITHOUT ALL BURNER PARTS AND DRIP PANS (IF SO EQUIPPED) IN PLACE.

Sealed Burner Assemblies (on some models)

Grate

Burner cap

Drip pan

(on some models)

Burner head

Electrode

Turn all controls OFF before removing the burner parts and drip pans (if so equipped).

The burner grates, caps, burner heads and drip pans (if so equipped) can be lifted off, making them easy to clean.

The electrode of

 

the spark igniter is

Electrode

exposed when the

burner head is removed. When one

burner is turned to LITE, all the burners spark. Do not attempt to disassemble or clean around any burner while another burner is on. An electric shock may result, which could cause you to knock over hot cookware.

Burner Heads (on sealed burners only)

NOTE: Before removing the burner heads and caps, remember their size and location. Replace them in the same location after cleaning.

For proper ignition,

make sure the small hole in the section that fits over the electrode is kept open. A sewing needle or wire twist-tie works well to unclog it.

The slits in the burner heads of your range must be kept clean at all times for an even, unhampered flame.

You should clean the surface burners routinely, especially after bad spillovers, which could clog these openings.

To remove burned-on food, soak the burner heads in a solution of mild liquid detergent and hot water for 20-30 minutes. For more stubborn stains, use a toothbrush.

Before putting the burner head back, shake out excess water and then dry it thoroughly by setting it in a warm oven for 30 minutes.

Replace the burner

heads and caps. Make sure that the heads and caps are

replaced in the correct location. There is one small, 2 medium and one large head and cap.

NOTE: On some models the burner heads and caps are all the same size and can be used in any of the 4 needed locations.

Burner Caps (on sealed burners only)

Lift off when cool. Wash burner caps in hot, soapy water and rinse with clean water. You may scour with a plastic scouring pad to remove burned-on food particles.

Dry them in a warm oven or with a cloth—don’t reassemble them wet. Replace the burner caps.

Make sure that caps are replaced on the correct size burner. There is one small, 2 medium and one large cap.

28

small

medium

small

 

medium

large

medium

large

 

 

 

 

Front of Range

NOTE: On some models the caps are all the same size and can be used in any of the 4 needed locations.

Page 27 Page 29
Image 28
Page 27 Page 29
Contents RangesXL44 Self-Cleaning Gas If YOU Need Service Help US Help YOU…Important Safety Instructions When You Get Your RangeSurface Cooking Clean only parts listed in this Use and Care Guide Save These InstructionsFeatures of Your Range Features and appearance varyOven Light On/Off Switch Automatic Oven Light Clock and Timer Oven on LightClean Light SeeSurface Cooking Top-of-Range Cookware Do not use a wok on a support ring. PlacingFeatures of Your Oven Control Cook Time ON/OFF. Press this for Timed Baking operationsOven CONTROL, Clock and Timer Using Your Oven Shelf Positions Oven ShelvesAutomatic Oven Shut Off Baking How to Set Your Range for BakingType of Food Shelf Position Pan Placement PreheatingBaking Guides CookiesPies CakesBaking Pans Don’t PeekHow to Set Immediate Start and Automatic Stop How to Time BakeTimed Baking How to Set Delay Start and Automatic Stop Questions and AnswersCan I use the minute timer during oven cooking? Quick ReminderAdjust the Oven Thermostat To Adjust the ThermostatDual Shelf Cooking RoastingUse of Aluminum Foil Roasting Guide Why is my roast crumbling when I try to carve it?Frozen Roasts Why are my meats not turning out as brown as they should? BroilingOven door must be closed during broiling Should I salt the meat before broiling?Broiling Guide BroilingBefore a Clean Cycle Operating the SELF-CLEANING OvenDo not rub or clean the door gasket How to Set the Oven for Cleaning To Stop a Clean CycleAfter a Clean Cycle Clean cycle time is normally 4 hoursHow to Set Delay Start of Cleaning on some models Can I clean the woven gasket around the oven door?Should there be any odor during the cleaning? Why do I have ash left in my oven after cleaning?Care and Cleaning Standard Twin Burners on some modelsSealed Burner Assemblies on some models For proper ignitionCooktop Surface Burner GratesOven Bottom Lift-Off Oven Door Broiler Pan and GridInside of the door Outside of the doorControl Panel and Knobs Oven Light Replacement on some modelsRemovable Storage Drawer on some models Oven Air Vents Removable Kick Panel on some modelsNever block the vents air openings of the range To raise the cooktopInstallation Instructions For Your SafetyImportant Safety Instructions General Provide Adequate GAS Supply Rigid Pipe Hookup for Models Equipped with Sealed Burners Extension Cord Cautions Electrical RequirementsIMPORTANT-Please read carefully Electric Disconnect Electric Ignition Models Yellow flamesTo remove the oven bottom Leveling the Range ⁄ 8 ″ Page Page QUESTIONS? Before YOU Call for SERVICE… Problem Possible CauseBefore You Call for Service Food does not We’ll Cover Any Appliance. Anywhere. Anytime Consumer Product Ownership Registration Warranty Service Telephone Numbers
Top Page Image Contents