GE LGB356, EGR2000, RGB744 manual ⁄ 8 ″

Page 43

1.Mark the wall where the RIGHT EDGE of the range is to be located. Be sure to allow for the countertop overhang if you intend to install the range next to cabinets.

	Anti-Tip
	device
Slotted
head	Wallplate
screw	Wallplate
Approx. 20°
21⁄8″	Marked edge
21⁄8″	of range

2.Locate the outside edge of the device 21⁄8″

toward the center of the range from the marked edge of the range.

3.Using the device as a template, mark the position of the hole for the screw.

4.For wood construction, drill a pilot hole at an angle of 20 degrees from the horizontal. A nail or awl may be used if a drill is not available.

Mount the Anti-Tip device with the screw provided.

For cement or concrete construction, you

will need a 1/4″ x 11⁄2″ lag bolt and a 1/2″ O.D. sleeve anchor, which are not provided. Drill the recommended size hole for the hardware.

Install the sleeve anchor into the drilled hole and then install the lag bolt through the device. The bolts must be properly tightened as recommended for the hardware.

	Wallboard	Back of
	Wallboard	range
		range

Anti-Tip device

Wood screw

Wallplate

5.Slide the range against the wall, and check for proper installation by grasping the front edge of the cooktop and carefully attempting to tilt the range forward.

WHEN ALL HOOKUPS ARE COMPLETED: MAKE SURE ALL CONTROLS ARE LEFT IN THE OFF POSITION.

MAKE SURE THE FLOW OF COMBUSTION AND VENTILATION AIR TO THE RANGE IS UNOBSTRUCTED.

CONVERTING TO LP GAS

(or converting back to natural gas from LP)

This range leaves the factory set for use with natural gas. If you want to convert to LP gas, the conversion must be performed by a qualified LP gas installer.

The conversion instructions, sticker and LP orifices can be found attached to the range next to the pressure regulator.

There is a second set of instructions included in the envelope containing the product wiring diagrams on the back of the range. Keep these instructions and the orifices in case you want to convert back to natural gas.

43

Image 43

Contents RangesXL44 Self-Cleaning Gas Help US Help YOU… If YOU Need ServiceWhen You Get Your Range Important Safety InstructionsSurface Cooking Save These Instructions Clean only parts listed in this Use and Care GuideFeatures and appearance vary Features of Your RangeSee Oven Light On/Off Switch Automatic Oven LightClock and Timer Oven on Light Clean LightSurface Cooking Do not use a wok on a support ring. Placing Top-of-Range CookwareCook Time ON/OFF. Press this for Timed Baking operations Features of Your Oven ControlOven CONTROL, Clock and Timer Using Your Oven Shelf Positions Oven ShelvesAutomatic Oven Shut Off Baking How to Set Your Range for BakingType of Food Shelf Position Cookies Pan PlacementPreheating Baking GuidesDon’t Peek PiesCakes Baking PansHow to Set Immediate Start and Automatic Stop How to Time BakeTimed Baking Quick Reminder How to Set Delay Start and Automatic StopQuestions and Answers Can I use the minute timer during oven cooking?To Adjust the Thermostat Adjust the Oven ThermostatDual Shelf Cooking RoastingUse of Aluminum Foil Roasting Guide Why is my roast crumbling when I try to carve it?Frozen Roasts Should I salt the meat before broiling? Why are my meats not turning out as brown as they should?Broiling Oven door must be closed during broilingBroiling Broiling GuideBefore a Clean Cycle Operating the SELF-CLEANING OvenDo not rub or clean the door gasket Clean cycle time is normally 4 hours How to Set the Oven for CleaningTo Stop a Clean Cycle After a Clean CycleWhy do I have ash left in my oven after cleaning? How to Set Delay Start of Cleaning on some modelsCan I clean the woven gasket around the oven door? Should there be any odor during the cleaning?Standard Twin Burners on some models Care and CleaningFor proper ignition Sealed Burner Assemblies on some modelsCooktop Surface Burner GratesOven Bottom Outside of the door Lift-Off Oven DoorBroiler Pan and Grid Inside of the doorControl Panel and Knobs Oven Light Replacement on some modelsRemovable Storage Drawer on some models To raise the cooktop Oven Air VentsRemovable Kick Panel on some models Never block the vents air openings of the rangeFor Your Safety Installation InstructionsImportant Safety Instructions General Provide Adequate GAS Supply Rigid Pipe Hookup for Models Equipped with Sealed Burners Extension Cord Cautions Electrical RequirementsIMPORTANT-Please read carefully Electric Disconnect Yellow flames Electric Ignition ModelsTo remove the oven bottom Leveling the Range ⁄ 8 ″ Page Page Problem Possible Cause QUESTIONS? Before YOU Call for SERVICE…Before You Call for Service Food does not We’ll Cover Any Appliance. Anywhere. Anytime Consumer Product Ownership Registration Warranty Service Telephone Numbers