Tools Needed, Attachment to wall, IN~Ry could Result

Anti-Tip Device Installation Instructions for Device Kit No. WBO6XO1O3

●ALL RANGES CAN TIP

I ● IN~Ry COULD RESULT

[ ● INSTALL ANTI-TIP

DEVICE PACKED WITH RANGE

●SEE INSTRUCTIONS

Tools Needed

Wall behind range

Attachment to wall

Fig. 2

Device

Wall plate

IIB* \ i

‘~

—

—— —

“

,#A&‘-

●Phillips head screwdriver

●17(” or adjustable wrench

●Flat blade screwdriver

Device attaches to floor or wall to hold either right or left rear leg leveler. If fas~ening to floor, b= sure that screws do not penetrate electrical wiring or plumbing. If this cannot be determined, use shorter screws that will not penetrate through flooring.

1.Decide whether the device will be installed on the right or left side of range— location.

2.If the device side of the range

is adjacent to a cabinet, place the device against back wall and cabinet as shown in figure 1.

If there is no adjacent cabinet, determine where the location of the range side (painted outside panel) will be. Place the device with its outside edge at this location and against back wall. See figure 1.

3.Determine whether you will anchor the device to the floor or to the wall as shown in figure 2. For greater stability fasten the device to both the wall and the floor if possible. Fasten the device securely with the screws provided. Screws are self-drilling in wood, plywood, particle and chip board,

and most metal framing. If attaching to masonry you can b~y suitable - screws and anchors at hardware stores. Use a masonry drill to drill the required holes.

4.Using the wrench, back out the four leg levelers at least two turns. See your installation guide for more leveling information before positioning range.

5.Slide the range into place.