Installation Instructions (continued)
Installing the Backguard
1.Place the backguard on top of the end panels at the rear of the range.
Leveling the Range
For proper cooking and baking the range must be leveled. Leveling legs are located on each corner at the base of the range.
2.Insert two machine screws through the holes at the bottom of each end cap. Secure the screws to the range frame with the hex nuts provided.
3.Insert two machine screws through the front of the backguard at each end. Secure the screws to the range frame with the hex nuts provided.
Install the oven shelves (see use and care section for instructions). Put a spirit level or a glass measuring cup partially filled with water on one of the oven shelves.
Use a lx” open end wrench or an adjustable wrench to back out the four leveling legs two or three turns each. Now use the wrench to adjust the leveling legs until the range is level.
Slide range back towards the wall being ca;eful not to damage the sides or top of the range, or the adjacent cabinets.
24
—