GE JBS07PI Operating Instructions Safety, Care and Cleaning, Lift-Up Cooktop on some models

Instructions

Care and cleaning of the range.

Be sure the controls are turned to OFF and the surface units are cool before attempting to remove them.

Operating Instructions Safety

Surface unit		Surface Units (on some models)
		To clean the surface units, turn the control
		to the highest setting for a minute. The coils
		will burn off any soil.
	Drip pan	To remove a surface unit:
Receptacle		To remove the drip pans for cleaning, the
		surface units must be removed first.
		Lift the surface unit about 2.5 cm (1 inch)
		above the drip pan and pull it out.
		Do not lift the surface unit more than 2.5 cm (1 inch).
		If you do, it may not lie flat on the drip pan when you
		plug it back in.
		Repeated lifting of the surface unit more
		than 2.5 cm (1 inch) above the drip pan can
		permanently damage the receptacle.

To replace a surface unit:

Replace the drip pan into the recess in the cooktop. Make sure the opening in the pan lines up with the receptacle.

Insert the terminals of the surface unit through the opening in the drip pan and into the receptacle.

Guide the surface unit into place so it rests evenly.

Do not immerse the surface units in liquids of any kind.

Do not clean the surface units in a dishwasher.

Do not bend the surface unit plug terminals.

Do not attempt to clean, adjust or in any way repair the plug-in receptacle.

Care and Cleaning

Drip Pans (on some models)

Remove the surface units. Then lift out the drip pans.

For best results, clean the drip pans by hand. Place them in a covered container (or a plastic bag) with 60 ml (1/4) cup ammonia to loosen the soil. Then scrub with a soap- filled scouring pad if necessary. Rinse with clean water and polish with a clean soft cloth.

The drip pans may also be cleaned in the dishwasher.

Clean the area under the drip pans often. Built-up soil, especially grease, may catch fire.

Do not cover the drip pans with foil. Using foil so close to the receptacle could cause shock, fire or damage to the range.

Troubleshooting Tips Installation Instructions

Be sure all surface units are turned off before raising the cooktop.

Lift-Up Cooktop (on some models)

Some models have a cooktop that can be lifted up for easier cleaning. The entire cooktop may be lifted up and supported in the up position.

The surface units do not need to be removed; however, you may remove one to make raising the cooktop easier. There are two side supports that lock into position when the cooktop is lifted up.

After cleaning under the cooktop with hot, mild soapy water and a clean cloth, lower the cooktop. Be careful not to pinch your fingers.

To lower the cooktop, push the rods back and gently lower the cooktop until it rests in place.

22