GE JBP84 Excessive smoking, During a clean cycle, Oven door will not, Clean cycle, Display

GEAppliances.com

Problem	Possible Causes	What To Do
Excessive smoking	Excessive soil.	• Touch the CLEAR/OFF pad. Open the windows to
during a clean cycle		rid the room of smoke. Wait until the LOCKED door
		light goes off. Wipe up the excess soil and reset the
		clean cycle.
Oven door will not	Oven too hot.	• Allow the oven to cool below locking temperature.
open after a clean cycle
Oven not clean after a	Oven controls not properly set.	• See the Using the self-cleaning oven section.
clean cycle
	Oven was heavily soiled.	• Clean up heavy spillovers before starting the clean
		cycle. Heavily soiled ovens may need to self-clean
		again or for a longer period of time.
“LOCK DOOR” flashes	The self-clean cycle has been	• Close the oven door.
in the display	selected, but the door is not
	closed.
LOCKED DOOR light	The oven door is locked	• Touch the CLEAR/OFF pad. Allow the oven to cool.
is on when you want	because the temperature
to cook	inside the oven has not
	dropped below the
	locking temperature.
“F—and a number	You have a function error code. • Touch the CLEAR/OFF pad. Put the oven back into
or letter” flash		operation.
in the display
	If the function code repeats.	• Disconnect all power to the range for at least 30
		seconds and then reconnect power. If the function
		error code repeats, call for service.
Control signals after	You forgot to enter a	• Touch the BAKE pad and desired temperature or
entering cooking time	bake temperature or	the SELF CLEAN pad and desired clean time.
or start time	cleaning time.
Display goes blank	A fuse in your home	• Replace the fuse or reset the circuit breaker.
	may be blown or the circuit
	breaker tripped.
	The clock is in the	• See the Special features of your oven control section.
	black-out mode.
Display flashes	Power failure.	• Reset the clock.
Unable to get the	Oven control pads were	• The BAKE and BROIL HI/LO pads must be touched at
display to show “SF”	not touched properly.	the same time and held for 3 seconds.
Power outage,	Power outage or surge.	• Reset the clock. If the oven was in use, you must reset
clock flashes		it by touching the CLEAR/OFF pad, setting the clock
		and resetting any cooking function.

37

Safety Instructions Operating Instructions Care and Cleaning Troubleshooting Tips Consumer Support