Sherwood RVD-9090R Operations, Adjusting Speaker Settings, Adjusting the speaker settings

ENGLISH

Operations

ADJUSTING SPEAKER SETTINGS

Adjusting the speaker settings			2			Select the desired speaker				SPEAKER MODE
						setting.
This receiver is equipped with circuitry that allows
the use of a wide range of speaker systems.
This circuitry works by redirecting the bass
frequencies or the entire channel to speakers that are				Each time this button is pressed, one of 11 different
capable of reproducing them.
				speaker settings is selected and displayed for 8
When a large or full range speaker capable of deep
				seconds as follows;
bass response is used for one of the channels, that
				FL		CS	RS, FL	CL	RS, FL	CL	RL,
channel should be set to L.
				FL		CL	RN, FL	CS	RL, FL	CN	RL,
When a small or satellite speaker with limited bass
				FL		CS	RN, FL	CN	RS, FS	CS	RS,
capability is used, that channel should be set to S.
Deep bass from that channel will be redirected to the				FS		CS	RN and FS CN RS.
main left and right speakers or to the subwoofer.				In the above, F stands for Front Speakers, C for
When there is no speaker available, that channel				Center Speaker, R for Rear Speakers, L for Large,
should be set to N. All the information in that				S for Small and N for None.
channel will be redirected to other available speakers.				Large speakers are capable of deep bass response
1	With the receiver in any of the SPEAKER MODE			and typically have one driver with a cone that is
	surround modes, press the			10 (25 cm) or larger.
	SPEAKER MODE button for			The following speaker settings cannot be selected:
	more than 2 seconds to enter			Front, Small : Center, Large : and Rear, Large(FS--
	the front-center-rear speaker			CL--RL) : or Center, None and Rear, None(CN--
	set-up mode.			RN).
The existing front-rear-center speaker setting is
displayed.
						Select the desired
This set-up mode is not available when 6 CH DIRECT			4							SPEAKER MODE
is selected as the input source or when ANALOG is						subwoofer setting.
selected as the signal input in the STEREO mode.
	Memorize the desired speaker	MEMO/ENTER
3				Each time this button is pressed, the subwoofer
	settings. Press the MEMO/
				setting changes and is displayed for 8 seconds as
	ENTER button while your
				follows;
	choice is displayed.
Your requested speaker settings are entered into					SUB W(oofer) -- Y(es): When using a powered
									subwoofer.
memory and the set-up procedure advances to the
					SUB W(oofer) -- N(o) : When not using a powered
subwoofer mode.
									subwoofer.
If the speaker setting display disappears before the
				If the front speakers are set to S(mall), the
MEMO/ENTER button is pressed, you must start
				subwoofer is automatically set to “Y”.
again from Step 1, above.
		MEMO/ENTER
5	Memorize the subwoofer			Checking the speaker setting
	setting. Press the
	MEMO/ENTER button while							SPEAKER MODE
	your choice is displayed.
Your requested subwoofer setting is entered into
memory.
If the subwoofer display disappears before the				Each time this button is pressed briefly, the front-
MEMO/ENTER button is pressed, you must start				center-rear speaker or subwoofer setting is
again from Step 2, above.				displayed.

12