Sherwood RVD-9090R Adjusting each channel level, Dolby Digital AC-3 or Dolby Pro, Logic Mode

Adjusting each channel level				7	Adjust the level of the selected
					channel as desired.
6	Select the channel to adjust.
					CHANNEL LEVEL
	CH SELECTOR				or	CHANNEL LEVEL
		or	CHANNEL
			SEL.
Each time this button is pressed, the corresponding				If the channel display disappears, you must start
				again from step 6, above.
channel is selected and displayed for 3 seconds in the
following order;
Front Left		Center	Front Right
SubWoofer		Rear Left	Rear Right	8	Repeat the above steps 6 and 7 to
If the receiver is in the STEREO mode, the center,					adjust the levels of the other channels.
rear and subwoofer channels are not available and
will not be displayed.
Speakers set to “N” are not available and will not be
displayed.
In Dolby Digital (AC-3) or Dolby Pro					Perform the adjustments in steps 6 to 8 in
Logic Mode					“Adjusting each channel level” until the
				10 sound from each speaker is perceived to be
In these modes, the volume level of each channel					equally loud.
can be adjusted using the test tone function.
9	Engage the Test Tone mode by pressing
	the Test Tone button on the remote
	control.
					Cancel the test tone function by pressing
		T.TONE		11 the Test Tone button on the remote control.
The test tone will cycle from channel to channel and
will be heard from each speaker for 2 seconds as
follows;					T.TONE
Front Left		Center	Front Right
SUBwoofer		Rear Left	Rear Right

Speakers set to “N” are not available and will not be displayed.

ENGLISH

13