GE PB750 Display goes blank, See the Special features of your oven control section, Unable to get

Page 34

Consumer Support Troubleshooting Tips Care and Cleaning Operating Instructions Safety Instructions

Before you call for service…

Troubleshooting Tips

Problem

 

Possible Causes

What To Do

 

 

 

 

 

Display goes blank

 

A fuse in your home may be

• Replace the fuse or reset the circuit breaker.

 

 

blown or the circuit breaker

 

 

 

tripped.

 

 

 

 

 

 

 

 

The clock is in the

• See the Special features of your oven control section.

 

 

black-out mode.

 

 

 

 

 

 

Display flashes

 

Power failure.

• Reset the clock.

 

 

 

 

 

Unable to get the

 

Oven control pads were

• The BAKE and BROIL HI/LO pads must be pressed

display to show “SF”

 

not pressed properly.

at the same time and held for 3 seconds.

 

 

 

 

 

Power outage,

 

Power outage or surge.

• Reset the clock. If the oven was in use, you must reset

clock flashes

 

 

 

it by pressing the CLEAR/OFF pad, setting the clock

 

 

 

 

and resetting any cooking function.

 

 

 

 

 

“Burning” or “oily”

 

This is normal in a new

• To speed the process, set a self-clean cycle for a

odor emitting from

 

oven and will disappear

minimum of 3 hours. See the Using the self-cleaning

the vent

 

in time.

oven section.

 

 

 

 

 

Strong odor

 

An odor from the insulation

• This is temporary.

 

 

around the inside of the

 

 

 

oven is normal for the first

 

 

 

few times the oven is used.

 

 

 

 

 

 

Drawer does not slide

 

Drawer is over-loaded or

• Reduce weight. Redistribute drawer contents.

smoothly or drags

 

load is unbalanced.

 

 

 

 

 

 

Warming drawer will

 

A fuse in your home may be

• Replace the fuse or reset the circuit breaker.

not work

 

blown or the circuit breaker

 

 

 

tripped.

 

 

 

 

 

 

 

 

Controls improperly set.

• See the Warming drawer section.

 

 

 

 

 

Excessive condensation

 

Liquid in drawer.

• Remove liquid.

in the drawer

 

 

 

 

 

Uncovered foods.

• Cover food with lid or aluminum foil.

 

 

 

 

 

 

 

 

Temperature setting too high.

• Reduce temperature setting.

 

 

 

 

Food dries out in the

 

Moisture escaping.

• Cover food with lid or aluminum foil.

warming drawer

 

 

 

 

 

Drawer not fully closed.

• Push drawer in until latch engages.

 

 

 

 

 

 

 

34

Page 33 Page 35
Image 34
Page 33 Page 35
Contents 49-80538-1 08-08 JR Write the model and serial numbers here Model # Serial #ANTI-TIP Device Safety Precautions Ge.comSafety Instructions Care and Cleaning Operating InstructionsSafety Instructions Oven Tips CareWarming Drawer on some models Instructions Safety Using the surface unitsInstructions Cleaning Troubleshooting Tips Consumer Support SafetyInstructions Care About the radiant surface units… Selecting types of cookware Tips Care and Cleaning Using the oven controlsUsing the self-cleaning oven section Cleaning Using the ovenConsumer Support Broiling Guide Consumer Support Troubleshooting Tips Care and CleaningHow to Set the Upper Oven for Broiling HI BroilTo Reset the Kitchen Timer Using the clock and kitchen timerTo Set the Kitchen Timer To Cancel the Kitchen TimerCleaning Operating Instructions Using the timed baking and roasting featuresSafety Instructions Consumer Support Troubleshooting TipsHour Shutdown Special features of your oven controlFahrenheit or Celsius Temperature Selection Tones at the End of a Timed CycleHour, 24-Hour or Clock Blackout Your control is set to use a 12-hour clockHow to Set Sabbath Feature for Regular Baking/Roasting Using the Sabbath featureCleaning Troubleshooting Tips How to Exit the Sabbath FeatureTo Adjust the Thermostat Adjust the oven thermostat-Do it yourselfType of margarine will affect baking performance When Using the Warming Drawer Using the warming drawer on some modelsTo Use the Warming Drawer To Crisp Stale Items Operating Instructions SafetyTemperature Selection Chart To Warm Serving Bowls and PlatesBefore a Clean Cycle Using the self-cleaning ovenHow to Set the Oven for Cleaning After a Clean Cycle How to Delay the Start of CleaningOperating Instructions Control Knobs Care and cleaning of the rangeHow to Remove Protective Shipping Film and Packaging Tape Oven VentControl Panel Painted SurfacesLift-Off Oven Door Oven Racks Troubleshooting Tips Consumer SupportOven Light Replacement Oven Heating ElementsStorage Drawer Removal on some models Instructions SafetyRemovable Warming Drawer Pan on some models To remove the drawerCleaning Cleaning the glass cooktopCare Cleaning Operating Glass surface-potential for permanent damageBefore you call for service… Problem Possible Causes What To DoOven temperature Clock and timerSee the Using the clock and timer section Do not workClean cycle Oven not clean after See the Using the self-cleaning oven sectionDuring a clean cycle Clean cycleDisplay goes blank See the Special features of your oven control sectionPower outage Display flashesWe’ll Cover Any Appliance. Anywhere. Anytime Consumer Product Ownership Registration Care and Cleaning Accessories Looking For Something More?GE Will Provide GE Electric Range WarrantyTips Consumer Support What GE Will Not CoverConsumer Support GE Appliances Website Schedule ServiceParts and Accessories Real Life Design Studio

PB750 specifications

The GE PB750 is a notable addition to the field of power generation, specifically designed for high-efficiency and reliability in the gas turbine market. This model represents a significant advancement in gas turbine technology, providing operators and utilities with an effective solution for meeting growing energy demands while minimizing environmental impact.

At the heart of the GE PB750 is its advanced aerodynamics and materials technology, which contribute to its superior performance. The turbine features a robust design that allows for increased efficiency and flexibility, making it capable of operating in various conditions. The incorporation of advanced cooling techniques ensures that the turbine can maintain optimal performance even at high temperatures, which is essential for meeting peak demand periods in electricity generation.

One of the standout features of the PB750 is its combined cycle capability, which maximizes the energy extracted from the fuel. This technology enables the turbine to use both gas and steam cycles, leading to a significant reduction in carbon emissions compared to traditional single-cycle plants. Furthermore, the GE PB750 is equipped with advanced emissions control systems, which help to further reduce NOx and CO2 emissions, making it compliant with stringent environmental regulations.

The control system of the GE PB750 is designed with digital technology that enhances operational efficiency. Advanced analytics and monitoring capabilities provide real-time insights into performance, allowing operators to make informed decisions. This digital integration also facilitates predictive maintenance, reducing downtime and ensuring the turbine operates at peak performance.

The PB750’s modular design provides greater flexibility in installation and maintenance, making it an attractive option for utility operators. The ability to perform maintenance and upgrades while the unit is operating contributes to overall efficiency and reduces outages.

In summary, the GE PB750 gas turbine exemplifies cutting-edge technology in the power generation sector. Its high efficiency, reduced emissions, and advanced digital controls make it a suitable choice for meeting the energy demands of the future while ensuring compliance with environmental standards. As the world shifts towards cleaner energy solutions, the PB750 stands out as a reliable and innovative option for power generation.
Top Page Image Contents