GE PB750 owner manual Using the oven, Cleaning, Consumer Support

Page 13

Using the oven.

ge.com

To avoid possible burns, place the racks in the desired position before you turn the oven on.

Safety

The oven has 6 rack positions.

Before you begin…

The racks have stop-locks, so that when placed correctly on the rack supports (A through F), they will stop before coming completely out, and will not tilt.

When placing and removing cookware, pull the rack out to the bump on the rack support.

To remove a rack, pull it toward you, tilt the front end up and pull it out.

To replace, place the end of the rack (stop-locks) on the support, tilt up the front and push the rack in.

CAUTION: When you are using the rack in the lowest position (A), you will need to use caution when pulling the rack out. We recommend that you pull the rack out several inches and then, using two pot holders, pull the rack out by holding the sides of it. The rack is low and you could be burned if you place your hand in the middle of the rack and pull all the way out. Be very careful not to burn your hand on the door when using the rack in the lowest position (A).

Instructions Operating Instructions

How to Set the Oven for Baking or Roasting

 

Touch the BAKE pad.

Type of Food

Rack Position

 

Touch the number pads to set the

Frozen pies (on cookie sheet)

D

 

 

oven temperature.

Angel food cake

A

 

 

 

Care

To change the oven temperature during the Bake cycle, touch the BAKE pad and set the new temperature.

Touch the START pad. When the oven starts to heat, the changing temperature will be in the display. The display starts changing once the temperature reaches 100°F.

Touch the CLEAR/OFF pad when baking is finished.

Bundt or pound cakes

B or C

Biscuits, muffins, brownies,

C or D

cookies, cupcakes,

 

layer cakes, pies

 

Casseroles

C or D

Turkey

A

and Cleaning

Center baking pans in the oven.

Preheating and Pan Placement

Preheat the oven if the recipe calls for it. Preheating is necessary for good results when baking cakes, cookies, pastry and breads.

To preheat, set the oven at the correct temperature. The control will beep when the oven is preheated and the display will show your set temperature.

This will take approximately 6–10 minutes.

Baking results will be better if baking pans are centered in the oven as much as possible. If baking with more than one pan, place the pans so each has at least

1 to 11⁄2″ of air space around it. If baking four cake layers at the same time, place two layers on rack B and two layers on rack D. Stagger pans on the rack so one is not directly over the other.

Troubleshooting Tips

Aluminum Foil

Do not use aluminum foil on the bottom of the oven.

Never entirely cover a rack with aluminum foil. This will disturb the heat circulation and result in poor baking.

A smaller sheet of foil may be used to catch a spillover by placing it on a lower rack several inches below the food.

13

Consumer Support

Page 12 Page 14
Image 13
Page 12 Page 14
Contents Write the model and serial numbers here Model # Serial # 49-80538-1 08-08 JRANTI-TIP Device Ge.com Safety PrecautionsCare and Cleaning Operating Instructions Safety InstructionsSafety Instructions Tips Care OvenWarming Drawer on some models Instructions Safety Using the surface unitsInstructions Cleaning Troubleshooting Tips Consumer Support SafetyInstructions Care About the radiant surface units… Selecting types of cookware Tips Care and Cleaning Using the oven controlsUsing the self-cleaning oven section Cleaning Using the ovenConsumer Support How to Set the Upper Oven for Broiling Consumer Support Troubleshooting Tips Care and CleaningBroiling Guide HI BroilTo Set the Kitchen Timer Using the clock and kitchen timerTo Reset the Kitchen Timer To Cancel the Kitchen TimerSafety Instructions Using the timed baking and roasting featuresCleaning Operating Instructions Consumer Support Troubleshooting TipsFahrenheit or Celsius Temperature Selection Special features of your oven controlHour Shutdown Tones at the End of a Timed CycleYour control is set to use a 12-hour clock Hour, 24-Hour or Clock BlackoutCleaning Troubleshooting Tips Using the Sabbath featureHow to Set Sabbath Feature for Regular Baking/Roasting How to Exit the Sabbath FeatureTo Adjust the Thermostat Adjust the oven thermostat-Do it yourselfType of margarine will affect baking performance When Using the Warming Drawer Using the warming drawer on some modelsTo Use the Warming Drawer Temperature Selection Chart Operating Instructions SafetyTo Crisp Stale Items To Warm Serving Bowls and PlatesBefore a Clean Cycle Using the self-cleaning ovenHow to Set the Oven for Cleaning How to Delay the Start of Cleaning After a Clean CycleHow to Remove Protective Shipping Film and Packaging Tape Care and cleaning of the rangeOperating Instructions Control Knobs Oven VentControl Panel Painted SurfacesLift-Off Oven Door Oven Light Replacement Troubleshooting Tips Consumer SupportOven Racks Oven Heating ElementsRemovable Warming Drawer Pan on some models Instructions SafetyStorage Drawer Removal on some models To remove the drawerCleaning Cleaning the glass cooktopCare Glass surface-potential for permanent damage Cleaning OperatingProblem Possible Causes What To Do Before you call for service…See the Using the clock and timer section Clock and timerOven temperature Do not workDuring a clean cycle See the Using the self-cleaning oven sectionClean cycle Oven not clean after Clean cyclePower outage See the Special features of your oven control sectionDisplay goes blank Display flashesWe’ll Cover Any Appliance. Anywhere. Anytime Consumer Product Ownership Registration Care and Cleaning Looking For Something More? AccessoriesTips Consumer Support GE Electric Range WarrantyGE Will Provide What GE Will Not CoverParts and Accessories Schedule ServiceConsumer Support GE Appliances Website Real Life Design Studio

PB750 specifications

The GE PB750 is a notable addition to the field of power generation, specifically designed for high-efficiency and reliability in the gas turbine market. This model represents a significant advancement in gas turbine technology, providing operators and utilities with an effective solution for meeting growing energy demands while minimizing environmental impact.

At the heart of the GE PB750 is its advanced aerodynamics and materials technology, which contribute to its superior performance. The turbine features a robust design that allows for increased efficiency and flexibility, making it capable of operating in various conditions. The incorporation of advanced cooling techniques ensures that the turbine can maintain optimal performance even at high temperatures, which is essential for meeting peak demand periods in electricity generation.

One of the standout features of the PB750 is its combined cycle capability, which maximizes the energy extracted from the fuel. This technology enables the turbine to use both gas and steam cycles, leading to a significant reduction in carbon emissions compared to traditional single-cycle plants. Furthermore, the GE PB750 is equipped with advanced emissions control systems, which help to further reduce NOx and CO2 emissions, making it compliant with stringent environmental regulations.

The control system of the GE PB750 is designed with digital technology that enhances operational efficiency. Advanced analytics and monitoring capabilities provide real-time insights into performance, allowing operators to make informed decisions. This digital integration also facilitates predictive maintenance, reducing downtime and ensuring the turbine operates at peak performance.

The PB750’s modular design provides greater flexibility in installation and maintenance, making it an attractive option for utility operators. The ability to perform maintenance and upgrades while the unit is operating contributes to overall efficiency and reduces outages.

In summary, the GE PB750 gas turbine exemplifies cutting-edge technology in the power generation sector. Its high efficiency, reduced emissions, and advanced digital controls make it a suitable choice for meeting the energy demands of the future while ensuring compliance with environmental standards. As the world shifts towards cleaner energy solutions, the PB750 stands out as a reliable and innovative option for power generation.
Top Page Image Contents