GE JBP74 owner manual After a Clean Cycle, How to Delay the Start of Cleaning

ge.com

The oven door must be closed and all controls set correctly for the cycle to work properly.

Safety

SELF

CLEAN

1 2 3 4 5

6 7 8 9 0

DELAY

START

1	2	3	4	5
6	7	8	9	0

START

How to Delay the Start of Cleaning

Make sure the clock shows the correct time of day.

Touch the SELF CLEAN pad.

Using the number pads, enter the desired clean time.

Touch the DELAY START pad. The earliest start time you can set will appear in the display.

Using the number pads, enter the time of day you want the clean cycle to start.

Touch the START pad.

The door locks automatically. The display will show the start time. It will not be possible to open the oven door until the temperature drops below the lock temperature and the LOCKED door light goes off.

When the LOCKED door light is off, open the door.

Instructions Operating Instructions

After a Clean Cycle

You may notice some white ash in the oven. Wipe it up with a damp cloth after the oven cools.

If white spots remain, remove them with a soap- filled steel wool pad and rinse thoroughly with a vinegar and water mixture.

These deposits are usually a salt residue that cannot be removed by the clean cycle.

If the oven is not clean after one clean cycle, repeat the cycle.

Apply a small amount of vegetable oil to a paper towel and wipe the edges of the oven shelves with the paper towel. Do not spray with Pam® or other lubricant sprays.

■You cannot set the oven for cooking until the oven is cool enough for the door to unlock.

■While the oven is self-cleaning, you can touch the CLOCK pad to display the time of day. To return to the clean countdown, touch the COOKING TIME pad.

Care and Cleaning Troubleshooting Tips Consumer Support

27